09-16-2014, 04:19 PM | #1 |
KaBoom1701
Drives: 13' ZL1 Red M6 Join Date: Dec 2012
Location: I.E. SoCal (Yucaipa)
Posts: 8,630
|
Any V6's with ZL1 grills?
Any V6'ers with the ZL 1 grill installed?
Post your pics if you got em. Thinking of doing this mod but I haven't seen too many on the V6 cars... Thx
__________________
Mods:
Roto-Fab Intake, WW Res. kit & Big Gulp Air Scoop, Elite Catch Can, ATI Super Damper & 18% OD Pulley, LF Idler pulley bracket, Metco CC breather, ID850 Injectors, Stainless Power Headers w/ ceramic coating, TR71X Spark Plugs, JMS Fuel Pump Booster, Bo White TB, Tuned by Ted @ Jannetty Racing, Ron Davis HX, D3 Reservoir, Pfadt 1" Springs, Moreno Camber Plates, ZL1 Addons Splitter guard washers, Tow Hook kit & rock guards, Hurst Shifter Billet Plus 6 Speed Short Shifter, ZL1 DRL lighting harness, ZL1 Recaro Seats. |
09-16-2014, 05:19 PM | #2 |
2015 SS 6M
|
__________________
|
09-16-2014, 05:22 PM | #3 |
KaBoom1701
Drives: 13' ZL1 Red M6 Join Date: Dec 2012
Location: I.E. SoCal (Yucaipa)
Posts: 8,630
|
Thx but I'm not looking foe the entire ZL1 front end conversion.
Just the ZL1 upper grill on a stock 2012-2013 V6 Camaro.
__________________
Mods:
Roto-Fab Intake, WW Res. kit & Big Gulp Air Scoop, Elite Catch Can, ATI Super Damper & 18% OD Pulley, LF Idler pulley bracket, Metco CC breather, ID850 Injectors, Stainless Power Headers w/ ceramic coating, TR71X Spark Plugs, JMS Fuel Pump Booster, Bo White TB, Tuned by Ted @ Jannetty Racing, Ron Davis HX, D3 Reservoir, Pfadt 1" Springs, Moreno Camber Plates, ZL1 Addons Splitter guard washers, Tow Hook kit & rock guards, Hurst Shifter Billet Plus 6 Speed Short Shifter, ZL1 DRL lighting harness, ZL1 Recaro Seats. |
09-16-2014, 06:31 PM | #4 |
Drives: Supercharged LLT Join Date: Aug 2012
Location: San Antonio, Texas
Posts: 1,437
|
Mine
|
09-16-2014, 06:33 PM | #5 |
Drives: 2010 ABM Camaro 1LT Join Date: Jun 2012
Location: Waterbury
Posts: 1,083
|
Mine
Sent from my SAMSUNG-SM-G900A using Tapatalk |
09-16-2014, 07:09 PM | #6 |
The Stealth Bumblebee
Drives: Black 2013 2LS Join Date: Aug 2013
Location: SW of Houston
Posts: 1,385
|
__________________
KILLER BEE
|
09-16-2014, 07:33 PM | #7 |
7 year Cancer Survivor!
Drives: 17 Cruze RS, 07 G6 GT, 99 Astro Join Date: Dec 2007
Location: East Tennessee
Posts: 21,547
|
Had mine for over a year.
__________________
Cancer's a bitch! Enjoy life while you can! LIVE, LOVE, DRIVE...
The Bird is the word! |
09-16-2014, 07:39 PM | #8 |
KaBoom1701
Drives: 13' ZL1 Red M6 Join Date: Dec 2012
Location: I.E. SoCal (Yucaipa)
Posts: 8,630
|
Ok,
Those look better than I though. SO how was with to install? Easy/hard? Anyone know where the best price is for this ZL1 upper grill? Thx
__________________
Mods:
Roto-Fab Intake, WW Res. kit & Big Gulp Air Scoop, Elite Catch Can, ATI Super Damper & 18% OD Pulley, LF Idler pulley bracket, Metco CC breather, ID850 Injectors, Stainless Power Headers w/ ceramic coating, TR71X Spark Plugs, JMS Fuel Pump Booster, Bo White TB, Tuned by Ted @ Jannetty Racing, Ron Davis HX, D3 Reservoir, Pfadt 1" Springs, Moreno Camber Plates, ZL1 Addons Splitter guard washers, Tow Hook kit & rock guards, Hurst Shifter Billet Plus 6 Speed Short Shifter, ZL1 DRL lighting harness, ZL1 Recaro Seats. |
09-16-2014, 08:01 PM | #9 | |
7 year Cancer Survivor!
Drives: 17 Cruze RS, 07 G6 GT, 99 Astro Join Date: Dec 2007
Location: East Tennessee
Posts: 21,547
|
Quote:
Prices vary.I got mine on EBay for $100 including shipping.
__________________
Cancer's a bitch! Enjoy life while you can! LIVE, LOVE, DRIVE...
The Bird is the word! |
|
09-16-2014, 08:02 PM | #10 |
The Stealth Bumblebee
Drives: Black 2013 2LS Join Date: Aug 2013
Location: SW of Houston
Posts: 1,385
|
I bought mine from Phastek Performance for $90.00. You have to remove the front bumper. You have 3 screws in the wheel well, 2 piston clips, 3 bolts, and a few more bolts around the back side of the side marker light (x2 for passenger side) It's quite easy once you get the hang of it. Deconstruction took me 45 min. Probably because I had to run to the hardware store to replace my misplaced 7 mm "ratchet bolt"! Construction took 15 min. The grill was a little scary to remove because it felt like I would rip it all out of shape, but it's held on to the fascia by maybe 12 clips but they peel off one after another. Then you got these 4 gator toothed clips that are hell to remove because you need a thin screwdriver and pry it off without bending the teeth because they are HARD to bend back. Don't sweat it cause it's no reason not to buy. You'll maybe need a rubber hammer to put new grille on. The Zl1 grille only came with 3 clip holes for the bow tie so you'll need to fix that up a little. Or just leave it off like on my previous post. Lol
__________________
KILLER BEE
|
09-16-2014, 09:04 PM | #11 |
Drives: '13 2LT/RS Twin Turbo Join Date: Aug 2012
Location: Edmond, Oklahoma
Posts: 3,073
|
I had one on for a few months, I liked it but never really decided what to put over the zl1 emblem area.. I ended up going back to the factory grill. I think it looks meaner. Plus I bought a zl1 suede steering wheel and didn't want TOO much zl1 stuff on my car lol just steering wheel and sway bars now.
|
09-16-2014, 09:12 PM | #12 |
Drives: 2010 ABM Camaro 1LT Join Date: Jun 2012
Location: Waterbury
Posts: 1,083
|
i can take my bumper off in about 5 minutes. once you know where everything is its not hard at all.
Sent from my SAMSUNG-SM-G900A using Tapatalk |
09-16-2014, 09:31 PM | #13 |
KaBoom1701
Drives: 13' ZL1 Red M6 Join Date: Dec 2012
Location: I.E. SoCal (Yucaipa)
Posts: 8,630
|
Ok, thx for the feed back guys.
I see phastek list these for $139 now. Guess the price has gone up. I sent an email to emblemspros and asked for a custom made LFX badge to go where the ZL1 badge would normal go.
__________________
Mods:
Roto-Fab Intake, WW Res. kit & Big Gulp Air Scoop, Elite Catch Can, ATI Super Damper & 18% OD Pulley, LF Idler pulley bracket, Metco CC breather, ID850 Injectors, Stainless Power Headers w/ ceramic coating, TR71X Spark Plugs, JMS Fuel Pump Booster, Bo White TB, Tuned by Ted @ Jannetty Racing, Ron Davis HX, D3 Reservoir, Pfadt 1" Springs, Moreno Camber Plates, ZL1 Addons Splitter guard washers, Tow Hook kit & rock guards, Hurst Shifter Billet Plus 6 Speed Short Shifter, ZL1 DRL lighting harness, ZL1 Recaro Seats. |
09-16-2014, 09:39 PM | #14 | |
The Stealth Bumblebee
Drives: Black 2013 2LS Join Date: Aug 2013
Location: SW of Houston
Posts: 1,385
|
Quote:
What did they quote you for the LFX emblem btw?
__________________
KILLER BEE
|
|
|
|
|
|