08-30-2017, 08:14 AM | #1 |
Drives: 2017 50th Anniversary 2SS Join Date: Sep 2016
Location: Jacksonville, FL
Posts: 930
|
Anyone connected Aeroforce Wideband to HPTuners?
I've got a wideband setup on my car via my Aeroforce Gauge. It's a Bosch LSU 4.9 sensor running through the aeroforce control box. Has anyone connected this to the HPTuners handheld? From what I read I add a split to the 5v analog signal wire over to my HPTuners. Just wanted to see if anyone has been there done that yet.
Thanks!
__________________
Former Ride: 17 Camaro 2SS, M6 - Fifty | Procharger P1SC | 3.7 Pulley | Stage 2 IC | Race Bypass | DSX FF Kit | JRE Custom E85 Flex Fuel Tune | LT4 Fuel System | JMS Voltage Booster | MSD Plug Wires | American Racing 1-7/8's LT Headers Full System Catback | Baro Breakout Harness | LT4 Map Sensor | Katech Ported TB | MMS Oil Catch Can | 160 Thermo | Solo Performance J-Pipes
|
09-02-2017, 08:29 AM | #2 |
Drives: 2017 50th Anniversary 2SS Join Date: Sep 2016
Location: Jacksonville, FL
Posts: 930
|
Just for future reference in case anyone ever does need this info.
Tap 2 wires into the Analog OUT cable from the Aeroforce Wideband control box. It says "Analog Out" and has a 3 wire harness plugged into it. Brown wire is the 5v Signal that goes to the HPTuners Aux Input 1. and the Black wire goes to the HPTuners #5 connector (Ground). Also disconnect the aeroforce gauge from its harness completely. It will throw off o2 readings if you don't.
__________________
Former Ride: 17 Camaro 2SS, M6 - Fifty | Procharger P1SC | 3.7 Pulley | Stage 2 IC | Race Bypass | DSX FF Kit | JRE Custom E85 Flex Fuel Tune | LT4 Fuel System | JMS Voltage Booster | MSD Plug Wires | American Racing 1-7/8's LT Headers Full System Catback | Baro Breakout Harness | LT4 Map Sensor | Katech Ported TB | MMS Oil Catch Can | 160 Thermo | Solo Performance J-Pipes
Last edited by Dysan911; 09-09-2017 at 09:15 AM. |
09-10-2017, 08:52 AM | #3 |
Drives: 2017 1ss m6. Blue..... Join Date: Mar 2017
Location: Macomb Michigan
Posts: 144
|
I have just a aero force and im looking at adding a wideband since im on e85. So are you refering to the hptuners gauge pod or the actual hookup that goes tovthe labtop?
|
09-10-2017, 08:58 AM | #4 |
Drives: 2017 50th Anniversary 2SS Join Date: Sep 2016
Location: Jacksonville, FL
Posts: 930
|
The actual hookup that goes to the laptop. I did figure it out though. See my post right above yours.
__________________
Former Ride: 17 Camaro 2SS, M6 - Fifty | Procharger P1SC | 3.7 Pulley | Stage 2 IC | Race Bypass | DSX FF Kit | JRE Custom E85 Flex Fuel Tune | LT4 Fuel System | JMS Voltage Booster | MSD Plug Wires | American Racing 1-7/8's LT Headers Full System Catback | Baro Breakout Harness | LT4 Map Sensor | Katech Ported TB | MMS Oil Catch Can | 160 Thermo | Solo Performance J-Pipes
|
09-19-2017, 12:53 PM | #5 |
Drives: BLUE CAMARO ZL1 1LE M6 Join Date: Jun 2009
Location: ON THE DYNO WATERBURY CT.
Posts: 15,223
|
Great info thanks for sharing.
__________________
www.jannettyracing.com
Celebrating 37 years Performance parts, Installation, Fabrication, Dyno tuning, Remote custom tuning, and alignments. 203-753-7223 Waterbury CT. 06705 email tedj@jannettyracing.com |
|
|
Post Reply
|
|
|