[Mrfixxit7]

I called them last week and they are now saying it will not be until the end of April until they are ready. I will be putting my side rocker on about that time so I will see but if they are not ready I will probably do the same.

[tecboy]

is this kit available yet?

[Mrfixxit7]

Just called today and they said it will not be ready until the end of summer.

[02fbody35th]

Originally Posted by Mrfixxit7

Just called today and they said it will not be ready until the end of summer.

Lol what a Joke!!! Like I said before. Why promote a product that is no where even close to production! Just follow the how to that another member made and I posted earlier in this thread. It works perfectly and it’s exact the same as gen5diy is trying to sell minus the 3D printed spacer. Which is replacing the washers in the right up.

[Mrfixxit7]

Originally Posted by 02fbody35th

Lol what a Joke!!! Like I said before. Why promote a product that is no where even close to production! Just follow the how to that another member made and I posted earlier in this thread. It works perfectly and it’s exact the same as gen5diy is trying to sell minus the 3D printed spacer. Which is replacing the washers in the right up.

I agree I am very disappointed and it is not good business practice. I will do the DYI mentioned earlier in the thread. I am thinking about using nylon spacer instead, that way I don’t have to worry about rust issues. If it turns out well I will post on the forum.