You are browsing camaro5 
 |
|
09-09-2015, 08:31 PM
|
#1 |
 
Drives: 2010 SS, 2000 Pontiac Formula Join Date: Mar 2013
Location: Missouri
Posts: 509
|
Inner tire wear
Ok I have extreme tire wear on the inside of my rear tires on my 2010 SS. The outsides still look good but the insides are bald/ showing wires. Tire pressure is at the recommended level, and alignment is good. What could be causing the extreme tire wear on the inside? Some one told me the camber comes messed up from the factory on the Camaros? I didn't have this issue on my 2012. Tires are RS3s. Anyone have any suggestions?
|
|
|
|
09-17-2015, 12:22 PM
|
#2 |
   Drives: 2010 CGM Camaro 2SS/LS3 Join Date: Oct 2013
Location: Raleigh-Durham
Posts: 1,409
|
You say alignment is good, but are you really sure? The other possibility is something is bent but that should show up on an alignment.
I doubt the bushings in the suspension are worn slap out, but you never know. Is the front suspension all stock? I wouldn't expect a little negative camber to cause any major inside wear issues, nothing that can be adjusted to with stock suspension anyway. Can you post the spec sheet from your last alignment?
__________________
2010 2SS
BMR 1" Springs Koni Orange struts/shocks 1LE rear sway bar SRP Racing Pedals Hurst Billet short shifter Square tire/wheel setup Elite Engineering Catch Can Stainless Power longtubes/highflow cats K&N Typhoon CAI RPM Motorsports of Garner, NC dyno tune (421 RWHP) |
|
|
|
|
09-17-2015, 01:07 PM
|
#3 |
Drives: 2017 Camaro 1SS 1LE Hyper Blue Join Date: Mar 2013
Location: Minnesota
Posts: 661
|
I just swapped my wheels and noticed the same thing. I haven't had an alignment yet but plan to shortly due to my new wheels and tires and not wanting them to wear prematurely.
__________________
2017 Camaro 1SS 1LE Hyper Blue
|
|
|
|
|
09-18-2015, 06:33 PM
|
#4 |
      Drives: cars Join Date: May 2011
Location: Oversneeze
Posts: 4,544
|
Your alignment is not good.
|
|
|
|
|
|
|
|
 |
|
|
