[ws2186]

Originally Posted by njdad61

I had a hunch that Chevy wouldn't completely redesign the top grill to accommodate the bowtie. Turns out I was right. A right-angle socket setup, T25 bit, and a flashlight was all I needed. The 2 T25 screws holding the badge backing in place are accessible through the hood latch opening.

Thanks for this info! Is that part # 84684148? Is there another part # visible on the bowtie itself?

The last part # ill be searching for after these would be for the middle panel with no flowtie. My plan is to delete the flowtie, but keep the center section all black, then add the bowtie up above. Car is white

[ZarusSS]

Now you just need a new front end.

[greg0ry]

Originally Posted by RLem619

Not knocking your car, i'm just one of the few who liked the black bumper with the Bowtie

We are the minority, my friend... >: )

[greg0ry]

Originally Posted by ws2186

Thanks for this info! Is that part # 84684148? Is there another part # visible on the bowtie itself?

The last part # ill be searching for after these would be for the middle panel with no flowtie. My plan is to delete the flowtie, but keep the center section all black, then add the bowtie up above. Car is white

I wanna see!!

[freddyD]

I think it looks good.remember whatever YOU like, i think it looks clean.

[metalhead79]

I like it without the bowtie.