[Tankman]

Hi there,
I just returned from the dealership after showing the rubbing marks on both door frames and the top bumper where the trunk lid hits. This is potentially a campaign now as the brand new on the lot 2.0 Camaro is showing early signs of it........Check yours out and report pls. Its a one inch rub mark, don't look at the reflection. The trunk issue is on the bumper right in the middle. It appears to be caused as the doors or trunk lid close and flex / rebound. It is a fit issue.
Anybody else having these problems with the 'fit'?
Tankman

Bumper.JPG

DOOR 1.JPG

[blade57]

Have the rub mark on the top of my Bumper. I'll check my door panels in better daylight.

Cheers


DaveD

[Michigan1LTRS]

I don't have any of that. Also, this would not be a problem just for the turbo. It's an alignment issue and could/would affect all models.

[Nfg2ss]

I noticed that right away on mine, both areas. Wasn't an alignment issue at all for me. The seam sealer on the door in the corresponding areas was just wayyy to thick. We shaved it down and used a little touch up paint on the exposed sealer. We caught it before it did any real damage, just had to buff it a bit in those areas and it's been fine ever since.

[Tankman]

Hi there,
184 have viewed this thread so far and only 3 have found similar problems........that's not too bad I thought it was going to more........
TM

[2SSRS@Gen5diy]

My car 2.0T had a trunk misalignment, and remove paint but when we move one side of the trunk lid to where it need to be we where fine, when we take to paint will have other paint fixed at the same time.