01-20-2013, 08:58 AM | #1 |
Helping Build America
Drives: 2010 2SS/RS,LS3 2013 Duramax 3500HD Join Date: Aug 2008
Location: Freeport LPG Export
Posts: 3,839
|
How the he** do you disconnect?
How does the wiring harness for the front seat disconnect? I don't see a tab to depress to make it come apart.
Any photos showing how? Can't find any in DIY section.
__________________
Life's journey is not to arrive at the grave safely in a well preserved body, but rather to skid in sideways, totally worn out, shouting "Holy shit, what a ride!"
|
01-20-2013, 09:55 AM | #2 |
Drives: Black 2011 Camaro LS Join Date: Feb 2011
Location: Texas
Posts: 1,694
|
If I remember correctly there is a flip tab. You don't push it down, you open it to unlock.
I MIGHT be wrong so don't break anything trying to do what I said. I vaguely remember from when I did my lighting install.
__________________
White Fender Hashes from Big Worm Graphix with Custom White Bowties
GM Factory Remote Start and Factory Key Fob SS Fascia, Factory RS HIDs, Plasma P13W fog lights Non-RS to RS and fog light harness by Gen5DIY LED Interior, Trunk, and Licence Plate lights in white ZL1 Spoiler with Gen5DIY harness Factory NPP cat back Blacked out tail light bezels Factory 20 inch wheels wrapped in Nitto Motivos Lowered 1.25inch on Eibach Pro springs |
01-20-2013, 10:32 AM | #3 |
Boosted Moderator
|
There is a big slide tab that covers two sides of the connector.
Reach under the seat, from the rear, and grab the front and rear edge of the slide tab... It's on the drivers side of the big connector... Pull it to the drivers side of the car about two or three inches, then the male part of the connector pulls out to the rear...
__________________
If the car feels like it is on rails, you are probably driving too slow. -Ross Bentley
Horsepower is how fast you hit the wall. Torque is how far you take the wall with you. “If everything seems under control, you're just not going fast enough.” Mario Andretti If you can turn, you ain't going fast enough... |
01-20-2013, 01:24 PM | #4 |
Helping Build America
Drives: 2010 2SS/RS,LS3 2013 Duramax 3500HD Join Date: Aug 2008
Location: Freeport LPG Export
Posts: 3,839
|
Thanks, I figured it out a while ago. Fixed the broken wire for seat heat, ready to put the seat back in.
When you sit in the seat, the wire gets pushed against part of the seat frame and eventually cuts the wire. I rerouted it so hope it stays good.
__________________
Life's journey is not to arrive at the grave safely in a well preserved body, but rather to skid in sideways, totally worn out, shouting "Holy shit, what a ride!"
|
|
|
|
|