[MagnumForceGB]

Had more time to look at it, the engine torque reading wasn't higher, so it didn't hit a higher cell. It looks like it would have failed eventually. Thing that worries me now is I used the same pressures that IndeedAZ and ETMX used in their tunes that are from FSP, but I upped the 1-2, 2-3, and 3-4 special oncoming pressure preset values for sport mode. Pressure was increased by 13%, so might have been just enough.

Now I get the decision, do I replace that line with a stock one or replace it with a steel braided line like I did for the trans cooler. Car will be down for a while though, gotta get new transmission fluid and make sure the trans isn't hurt.

It happened at very low speed, barely was on the throttle and the tires started spinning and white smoke was coming out hard. Engine bay is a complete mess, fluid everywhere. Going to have to run a ton of water on it to clear it out.