CAMARO6 - View Single Post

KMPrenger · 11-17-2013, 01:08 PM

This isn't a big suggestion, but one I'd like to see.

If you look at the pictures you posted of the 5th gen model next to your concept 6th gen, look at how the sheet metal is flat around the wheel well edges on the 5th gen, whereas on your concept the sheet metal doesn't have this little flat area. The body curve just continues on to the edge of the wheel well.

I could be wrong, but I think this slight change could be an improvement to your design.

I agree with ALLTRBO about raising the lower half of the fascia.

11-17-2013, 01:08 PM	#207
KMPrenger Drives: 16 Camaro SS, 15 Colorado Join Date: May 2009 Location: Jefferson City, Missouri Posts: 13,943	This isn't a big suggestion, but one I'd like to see. If you look at the pictures you posted of the 5th gen model next to your concept 6th gen, look at how the sheet metal is flat around the wheel well edges on the 5th gen, whereas on your concept the sheet metal doesn't have this little flat area. The body curve just continues on to the edge of the wheel well. I could be wrong, but I think this slight change could be an improvement to your design. I agree with ALLTRBO about raising the lower half of the fascia. __________________ 2016 Camaro 1SS - 8-speed - NPP - Black bowties 2010 Camaro 1LT V6 (Sold. I will miss her!)