View Single Post
Old 01-27-2013, 06:47 PM   #50
96MrBass

 
96MrBass's Avatar
 
Drives: GM
Join Date: Sep 2010
Location: Marydel, DE
Posts: 1,321
Quote:
Originally Posted by FINALLYSATISFIED View Post
GM, just me personally but id take some consideration into making the ZL1, Z/28 models (or whatever high end model you deicde to go with) harder for others to make there LS/LT/SS into them. It may be impossible but owning several models I've never been the type to slap other models parts on it to make it a clone(unless it was produced that way from factory, i.e 1LE). It may be harder to manufacture but making it extremely difficult would deter others to clone.

Some may disagree but owning a ZL1 I've seen alot of cloning/copying going on as of lately, from the 1LE/ZL1 rims, to ZL1 conversion kits. It makes owning an actual ZL1 alittle less pleasing. I understand rims being easy to buy but making exterior changes to the body dramatically will make people think twice about doing major modifications. Simple bolt-on parts are what is making people do it, take that way, and that'll cure that issue. I understand you'll stay have the die hard cloners but giving them some speed bumps could be easy. Just like its hard for others to install the mylink Nav into older models the same could be done for other areas.

Just my thoughts and opinions. Thanks.
It looks like GM got a few good ideas from other vendors when it came to the ZL1. The Havoc rockers were already out before it and some aftermarket spoilers.IMO
__________________
Roto- Fab Cai, SLP 1 3/4" headers, 3"X pipe, LM2 cat back, Comp Cam & AI Heads, SLP UP, RPM Tuned, GPI Intake, Vmax TB, ADM Air Scoop, 3.91 Gears, Gforce driveshaft, Braille 21#, Elite Catch Can, Pfadt Tie Rods, Diff Bushings and Trailing arms, Eibach spings & sways, BMR cradle bushings, Nt555r's.
96MrBass is offline