|
Installed my cam in the driveway. The oil pump was my biggest issue. Came off ok. Install with the o-ring on to the pickup tube was tight and the angle would not line up. Thought for sure I would cut/damage the o-ring. Even used the aftetmarket girdle to help with the pickup tube. It was a struggle. I used feeler gauges to align the pump, primed it by removing the plug on the driver's side block. When starting, held the gas pedal to the floor. This is a flood condition that will allow the engine to crank and build oil pressure, without starting.
__________________
GPI SS3 Cam & stuff,N.O. Plate(dedicated fuel tank,progressive,fuel hose upgrade,remote opener,heater,console switches),LNC2000,CTAP,ARH 1 7/8" LTs/gutted cats/X pipe/mufflers,Jet Hot coated LTs,GPI HPT Tune,CAI, Scoop,Rx Catch Can,Gates heater hose relocation, Remote clutch & auto brake res,Metco loop,Momentum Tunnel Brace,TSW Nurb 18",555 & 05,Pfadt trailing arms & toe rods,Autometer WB,Fesler Pillar Pod,LED strips (int),Lloyds floor & trunk mats,LED DRL/front turn & license plate,DRL harness,VLEDs tail lights,Plasticoat Bowties. Ord: Oct 5, 2009 Rec: Nov 19, 2009 13.17@112.6 stock
|