View Single Post
Old 05-07-2016, 01:42 AM   #7
spadz93
BUMBL Z
 
spadz93's Avatar
 
Drives: 2015 ZL1
Join Date: Nov 2013
Location: Northern NJ
Posts: 2,577
Quote:
Originally Posted by camaro2ss/rs View Post
NICE LIST... BUT IF YOU ARE LOOKING FOR GET RID OF JUST THE rear wheel hop, that list is over kill.....
What would you eliminate then? I'm just following the thread found in the suspension section on eliminating wheel hop, wasn't sure if it was a "pick one" or "go for all three" so I figured the extra upgrades can't hurt.

Quote:
Originally Posted by JCunningham View Post
get full cradle bushings. the Delrin are the best. you can do aluminum too. There will be no noise adding solid cradle bushings. cradle bushing make a big difference.
Duly noted, I'll check them out.
__________________
Sold: 2015 ZL1 M6, Rotofab Intake, LS3 throttle body, 2.55 Upper/9.17 Lower, Custom Camshaft, DMS Reinforced Brick, ID1050X, 1 7/8" Headers, ProSpeed HX/Reservoir, DSX Aux Pump/Flex Fuel Sensor, E85, McLeod RXT, BMR 1" Drop, 680rw 93/750rw E85, Tuned by CSP
Sold: 2010 2SS, some bolt ons, 415rwhp/400rwtq

spadz93 is offline   Reply With Quote