CAMARO6 - View Single Post - PHASE.2 MODS

Smokin19 · 05-06-2024, 07:21 AM

While just doing my oil change on the lift I found my cats were shot. I bought the ARH headers with their cats and they were gone (rattling) in 5k miles. I replaced them with GESI high flow cats. I also decided to go back to the NPP exhaust as the AWE Touring axle backs were just too loud. What I found out is the Kong Xport I did with the WeaponX lid allows the whine sound to really be heard, especially in touring mode. So for now I feel like I have what I was really looking for in a build. Good luck going forward.

05-06-2024, 07:21 AM	#229
Smokin19 Drives: 19' ZL1 A10, w/pdr Join Date: Sep 2014 Location: S.W. ohio Posts: 1,575	While just doing my oil change on the lift I found my cats were shot. I bought the ARH headers with their cats and they were gone (rattling) in 5k miles. I replaced them with GESI high flow cats. I also decided to go back to the NPP exhaust as the AWE Touring axle backs were just too loud. What I found out is the Kong Xport I did with the WeaponX lid allows the whine sound to really be heard, especially in touring mode. So for now I feel like I have what I was really looking for in a build. Good luck going forward. __________________ BTR Stg II cam w/ 38% fuel lobe, ARH 2" headers into 3" w/cats, Kong X port, Weapon X triple ht exchangers, NW 103, Rotofab big gulp, DSX lowside, TCM tune, BMR Lockout, Mustang dyno 720 rwhp, 634 rwtq on 93 pump.