Quote:
Originally Posted by teddyca
No you can't. Here is another issue. You are drilling a metal pin out which results in flaming hot shavings. You would trash your interior.
|
Valid point teddyca (sorry I have missed out your reply back in 2022).
However if you put proper covers on the floor, seats, door sill (I don't expect hot shavings to reach the roof or open door - not enough kinetic energy) or even better to add to that (as someone suggested before) a strong magnet to fetch the shavings before they go flying, this should be doable, right?
I was wondering if you have a proper access to start drilling when the seat is still in the car but nobody is raising concerns.
__________________
Camaro SS 2017 Convertible, 2SS trim, V8 6.2L 455HP 618Nm, A8, Silver
Mods so far: K&N oil air filter, rear lamps EU conversion with sequential turn signal, exhaust modification to 4 tips (non-NPP), LED rear fog light (EU requirement), side-markers conversion to LED
Mods planned: Morimoto LED lamps set (front)
