Quote:
Originally Posted by ZX-10R
Elite makes a much larger "ultra" can for higher flow/hp applications, the challenge becomes where to fit it
https://www.camaro6.com/forums/showthread.php?t=596538
Just venting the blowby is retarded. Separator volume must be based on flow, that's design 101
There are plenty of shops that use Elite cans so that's also wrong, and furthermore "x shop uses it" doesn't prove anything
|
LOL. The can is vented when it needs to vent. Why is this so hard for you to understand ??? Where do you actually think blowby goes?? It just vanishes into thin air under high boost?
I’ll tell you where it goes. It stays in the crankcase until in can be scavenged or until seals blow.
And yes it does matter what shops use because they have the experience, you don’t.
I don’t know of any shop on the east coast that installs elite cans.
Your hilarious man.
__________________
928rwhp - 93 | 1040rwhp/898rwrq - E65 SAE
LME 377 LT4 Short Block | Magnuson 2650 80mm upper w/13% lower (9.06) | DSX Lid & Valve Covers | CSP Custom Cam w/32% fuel lobe | CID Heads | NW 103mm TB | Roto Fab Big Gulp | CSP 2" Headers w/Green GESI Gen 2 Cats | Borla 3" Full Cat Back w/ S-Type| Mighty Mouse Wild Catch Can| Custom Holley Low side Fuel system| TooHigh PSI Port Injection w/Holley Controller | Forced Inductions Interchiller w/2 gallon fender tank | TK Performance built 10L90