Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 500
Search took 0.06 seconds.
Search: Posts Made By: FrankT
Forum: Suspension / Brakes / Chassis 09-05-2022, 06:24 PM
Replies: 18
Views: 3,036
Posted By FrankT
I have KW Variant 3 and they are not good. I have...

I have KW Variant 3 and they are not good. I have the fronts adjusted one click from full stiff to keep the strut from bottoming out. The rears are leaking after only 5K miles. Spend your money...
Forum: Exterior Parts & Accessories 08-24-2022, 06:54 AM
Replies: 7
Views: 2,636
Posted By FrankT
Sent you a PM...

Sent you a PM...
Forum: Forced Induction - V8 08-21-2021, 11:44 AM
Replies: 38
Views: 7,934
Posted By FrankT
FWIW, my Huron twin turbo car can't run any more...

FWIW, my Huron twin turbo car can't run any more than 12 degrees under boost without some KR creeping in. This is on 93 pump gas. But, I'll trade timing for boost any day.
Forum: Forced Induction - V8 08-09-2021, 07:36 AM
Replies: 38
Views: 7,934
Posted By FrankT
It's my understanding that he was on 91 octane...

It's my understanding that he was on 91 octane pump gas. VVE tables were not adjusted and were disabled.
Forum: Forced Induction - V8 08-02-2021, 03:05 PM
Replies: 38
Views: 7,934
Posted By FrankT
I looked at his tune. There were multiple rookie...

I looked at his tune. There were multiple rookie tuning errors. Timing tables had 18 to 21 degrees of timing under boost, MAP offset had not been corrected for the 3 bar MAP sensor, Power enrichment...
Forum: 5th Gen Camaro SS LS LT General Discussions 07-18-2021, 09:15 AM
Replies: 8
Views: 1,862
Posted By FrankT
There is a TSB about it, early model V8 cars....

There is a TSB about it, early model V8 cars. Serial number breakpoints are A9000406 to A9106537.
Forum: Forced Induction - V8 06-19-2021, 08:55 AM
Replies: 12
Views: 3,805
Posted By FrankT
If that pump does indeed run hot, I wonder if you...

If that pump does indeed run hot, I wonder if you modified the settings in the FPCM to slow it down a bit at normal driving conditions. Leave it turned up at WOT.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 06-11-2021, 02:44 PM
Replies: 9
Views: 3,142
Posted By FrankT
Check your battery condition. My car did almost...

Check your battery condition. My car did almost the same thing and it was the battery. I charged the battery and every thing was fine, but I went and replaced it anyway since it was five years old....
Forum: Forced Induction - V8 05-10-2021, 04:57 PM
Replies: 32
Views: 5,102
Posted By FrankT
I'm running a pair of the Comp oil less 6262...

I'm running a pair of the Comp oil less 6262 (with liquid cooled center section) on my Huron Speed twin kit. Coming up on three thousand miles since the install which is when Comp says they need to...
Forum: Forced Induction - V8 04-08-2021, 03:35 PM
Replies: 9
Views: 1,101
Posted By FrankT
If you really want to learn to tune, I highly...

If you really want to learn to tune, I highly recommend The Tuning School in Odessa, FL. I bought their tuning printed course and later went to one of their hands on schools. They teach a lot there...
Forum: Forced Induction - V8 04-07-2021, 11:51 AM
Replies: 9
Views: 1,101
Posted By FrankT
You shouldn't need to rescale the MAF, the Gen 4...

You shouldn't need to rescale the MAF, the Gen 4 has more than enough room to work just fine. I tuned my 2010 Huron Speed twin setup myself. I am running a MAF only tune, and it works well. I spent...
Forum: Forced Induction - V8 03-18-2021, 04:53 PM
Replies: 55
Views: 9,653
Posted By FrankT
Has anyone tried tuning the traction control...

Has anyone tried tuning the traction control tables? I added about twenty percent to those and leaving the traction control on. Spins just a little, but doesn't get out of control. This is on my...
Forum: Wheels / Tires 03-17-2021, 02:48 PM
Replies: 145
Views: 32,238
Posted By FrankT
Tried to send a PM, but it didn't go through. I...

Tried to send a PM, but it didn't go through. I need a price on black chrome, ZL1 sizes 20x10, 20x11 for a 2010 SS.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-16-2021, 08:12 AM
Replies: 22
Views: 3,994
Posted By FrankT
GM specifies to use the torque box locations....

GM specifies to use the torque box locations. Those are on the body a little further back from the subframe, just outside of the frame rail.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-01-2021, 11:12 AM
Replies: 17
Views: 3,423
Posted By FrankT
Glad to see you finally got it running. You'll...

Glad to see you finally got it running. You'll probably be happy at nine or ten pounds boost. I think it would be more streetable at that level.
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 01-13-2021, 04:04 PM
Replies: 11
Views: 3,848
Posted By FrankT
I second the Continental Extreme Contact Sport...

I second the Continental Extreme Contact Sport tires. I put a set on my 2010 Camaro in 275/305 and like them so much I am ordering a set for my 2017 ZO6.
Forum: Member Car Journals 07-02-2020, 08:05 AM
Replies: 326
Views: 60,403
Posted By FrankT
The engine compartment as is looks now. I am...

The engine compartment as is looks now. I am finishing up a twin turbo installation. Kit is from Huron Speed with Comp 6262 oil less turbos.
Forum: Member Car Journals 06-30-2020, 08:12 AM
Replies: 326
Views: 60,403
Posted By FrankT
Here's a few pics from the tow hook and front...

Here's a few pics from the tow hook and front splitter rods installation.
Forum: Member Car Journals 06-29-2020, 03:36 PM
Replies: 326
Views: 60,403
Posted By FrankT
Bringing this thread back from the dead, here's a...

Bringing this thread back from the dead, here's a few shots of the cam swap I did a couple of months ago. BTR Stage 2 Turbo cam and valve spring change, along with the new Comp Cams shaft rocker arm...
Forum: Forced Induction 06-24-2020, 01:18 PM
Replies: 9
Views: 2,600
Posted By FrankT
I'm almost done with the twin turbo install. I...

I'm almost done with the twin turbo install. I was going to post an install thread, but you can't get this kit from Huron Speed anymore. They have an upgraded kit that is available for pre-order now.
Forum: Forced Induction 06-24-2020, 12:03 PM
Replies: 9
Views: 2,600
Posted By FrankT
System has been sold!

System has been sold!
Forum: Ask the Camaro Team 06-17-2020, 01:03 PM
Replies: 2
Views: 3,455
Posted By FrankT
The 5th Gen caliper bolts are TTY, one time use...

The 5th Gen caliper bolts are TTY, one time use only and should be replaced as per GM instructions. The 6th Gen bolts can be reused after cleaning and applying new threadlocker. 6th Gen specs: First...
Forum: Forced Induction 06-13-2020, 08:43 PM
Replies: 9
Views: 2,600
Posted By FrankT
Price drop to $3000.

Price drop to $3000.
Forum: Forced Induction 06-01-2020, 03:07 PM
Replies: 9
Views: 2,600
Posted By FrankT
Huron Speed single turbo kit for sale

***SOLD!!***

Huron Speed Single Turbo Kit $3000.00

See the install thread on Camaro 5.com here, with plenty of pics:

https://www.camaro5.com/forums/showthread.php?t=562610

Huron Speed...
Forum: Tuning / Diagnostics -- engine and transmission 05-06-2020, 07:46 AM
Replies: 7
Views: 2,169
Posted By FrankT
There's a few videos on YouTube on how to do...

There's a few videos on YouTube on how to do this. Check out The Tuning School videos.
Forum: Forced Induction - V8 05-06-2020, 07:41 AM
Replies: 10
Views: 2,494
Posted By FrankT
I didn't have any cooling issues with anything...

I didn't have any cooling issues with anything when the car was single turbo. I'm switching to twins now, I'll see how it works but I don't anticipate any problems. I do have an oil temp gauge...
Forum: Forced Induction - V8 05-03-2020, 12:09 PM
Replies: 10
Views: 2,494
Posted By FrankT
Here is what I did on mine. I made custom...

Here is what I did on mine. I made custom brackets to mount it with the Huron Speed intercooler.
Forum: Forced Induction - V8 05-03-2020, 08:58 AM
Replies: 10
Views: 2,494
Posted By FrankT
I removed the factory cooler and installed one...

I removed the factory cooler and installed one using parts from Improved Racing. Now they offer a kit that should make it easier. Not cheap though....
Forum: Forced Induction - V8 03-05-2020, 07:59 AM
Replies: 17
Views: 3,120
Posted By FrankT
Thanks for all the responses, everyone. I...

Thanks for all the responses, everyone. I appreciate the help.
Frank
Forum: Forced Induction - V8 03-03-2020, 08:29 AM
Replies: 17
Views: 3,120
Posted By FrankT
Boost Controller recommendations

I'm probably going to install a boost controller on the Huron Speed twin kit I have. For the people who have done this, did you use one solenoid or two? I think there are advantages to doing it...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 03:41 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.