Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.07 seconds. Search: Posts Made By: Megahurtz
Forum: ZL1 Discussions Today, 08:40 AM
Replies: 8
Views: 62
Posted By Megahurtz
Don't wash the tires and wheels when the brakes...

Don't wash the tires and wheels when the brakes are hot. Also, it helps if you move the car after you wash it rather than just wash the car and leave it sit. I pull the car out of the garage and wash...
Forum: 2016+ Camaro: 6th Gen Camaro general forum Today, 07:24 AM
Replies: 4
Views: 156
Posted By Megahurtz
about 3 HP

about 3 HP
Forum: ZL1 Discussions 05-09-2024, 01:32 PM
Replies: 10
Views: 606
Posted By Megahurtz
They did the same thing with the Gen 4 and the...

They did the same thing with the Gen 4 and the Gen 5 and now the Gen 6. It likely has to do with the Electric car and fuel/emissions requirements from the Government and they aren't sure it will make...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-08-2024, 06:49 PM
Replies: 177
Views: 19,789
Posted By Megahurtz
Resurrecting this thread. When this thread was...

Resurrecting this thread. When this thread was made I looked and made sure I was opted out of Smart Driver. But then I got a huge increase in insurance. Then I looked and all of the sudden my data...
Forum: Forced Induction Discussions 05-06-2024, 01:21 PM
Replies: 18
Views: 852
Posted By Megahurtz
Check the main coil pack connector plug on the...

Check the main coil pack connector plug on the driver side.
Forum: ZL1 Discussions 05-06-2024, 01:20 PM
Replies: 25
Views: 969
Posted By Megahurtz
I have tested it and it seems to hold true. The...

I have tested it and it seems to hold true. The 1LE SS cars get the ZL1 low side pump which I assume is now the C7 ZR1 low side from 2022+. No REAL proof on this other than I see the 2019 Z06's (with...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-06-2024, 08:01 AM
Replies: 16
Views: 682
Posted By Megahurtz
Bolt on LT1 cars can run full pump E. (78-82%)....

Bolt on LT1 cars can run full pump E. (78-82%). Some of the older LT1's will benefit from a JMS on the low side but any 1LE SS will have the ZL1 low side. 2022+ Camaro's seem to have slightly better...
Forum: ZL1 Discussions 05-05-2024, 07:49 AM
Replies: 25
Views: 969
Posted By Megahurtz
It varies. 2022+ ZL1's seem to have a stronger...

It varies. 2022+ ZL1's seem to have a stronger OEM low side (allegedly its the C7 ZR1 low side).

You certainly don't need anything more than a JMS BAP for this level of mods on E50 for any year...
Forum: ZL1 Discussions 05-04-2024, 02:39 PM
Replies: 25
Views: 969
Posted By Megahurtz
Low side is needed. Didn't mention it because...

Low side is needed. Didn't mention it because it's mandatory and part of any Flex Fuel setup we do.
Forum: Forced Induction Discussions 05-04-2024, 08:16 AM
Replies: 18
Views: 852
Posted By Megahurtz
check the exhaust all the way from the manifold...

check the exhaust all the way from the manifold gaskets down to the header rear flange. Could also have a bad O2.

But also keep in mind, if a cylinder is misfiring, the O2's will read rich and try...
Forum: ZL1 Discussions 05-04-2024, 08:02 AM
Replies: 7
Views: 571
Posted By Megahurtz
We recommend Soler to all of our customers and...

We recommend Soler to all of our customers and have used all versions of Mike's products. Great product. Great Customer Service. Fast Shipping.

My partner and I use Soler on our personal/shop...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 05-03-2024, 05:51 AM
Replies: 19
Views: 803
Posted By Megahurtz
Taking the oil cap off and the squealing stops is...

Taking the oil cap off and the squealing stops is the key here.

You're pulling too much vacuum on the crankcase and its actually drawing air into the engine through the crank seal. That is the...
Forum: ZL1 Discussions 05-02-2024, 03:44 PM
Replies: 25
Views: 969
Posted By Megahurtz
I agree. I've got E50 cars with a 2.3 upper &...

I agree. I've got E50 cars with a 2.3 upper & headers running a drop in filter on the stock airbox pulling draggy times equal or faster than the same setup plus a rotofab. It's just not a restriction...
Forum: ZL1 Discussions 05-02-2024, 01:11 PM
Replies: 25
Views: 969
Posted By Megahurtz
But no dyno graphs to see if the differences were...

But no dyno graphs to see if the differences were just the normal spikes and dips on a dyno vs actually seeing a gain or loss across the whole range. Either way they are all within the range of dyno...
Forum: ZL1 Discussions 04-29-2024, 08:00 AM
Replies: 11
Views: 686
Posted By Megahurtz
I've never owned an LS or LT motor that didn't...

I've never owned an LS or LT motor that didn't burn about 1/4 - 1/2 quart of oil every 5000 miles or so, regardless of the break in procedure. If you drive the car hard it's going to burn a little...
Forum: Tuning / Diagnostics 04-28-2024, 05:00 PM
Replies: 40
Views: 2,830
Posted By Megahurtz
Yes and yes

Yes and yes
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-28-2024, 04:51 PM
Replies: 14
Views: 975
Posted By Megahurtz
hptuners.com Buy the mpvi3 and the required...

hptuners.com

Buy the mpvi3 and the required licenses for the CCM which I think is 3 credits. Someone else mentioned that in older cars, the exhaust valve control was in the FPCM, however I've...
Forum: Tuning / Diagnostics 04-27-2024, 03:01 PM
Replies: 40
Views: 2,830
Posted By Megahurtz
Your thoughts about COT pulling SOI back to where...

Your thoughts about COT pulling SOI back to where the exhaust valve is still open are exactly what got me thinking about the theory that it would actually cool the exhaust valve down and even the...
Forum: Forced Induction Discussions 04-27-2024, 08:24 AM
Replies: 10
Views: 466
Posted By Megahurtz
^^ Listen to Joshinator99. He is correct. Don't...

^^ Listen to Joshinator99. He is correct. Don't push the stock LT1 valve train past 6700. It won't survive long at your power level and you'll be rebuilding the engine.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-27-2024, 08:15 AM
Replies: 14
Views: 975
Posted By Megahurtz
I do it often with HPTuners. They define the CCM...

I do it often with HPTuners. They define the CCM for most Corvettes and Camaros already.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-27-2024, 08:14 AM
Replies: 14
Views: 975
Posted By Megahurtz
Options: #1 HPTuners, tune the CCM and have...

Options:

#1 HPTuners, tune the CCM and have them work any way you want
#2 Get a M2W switch which basically puts the NPP valve fuse on a remote switch that you can open and close whenever you...
Forum: Forced Induction Discussions 04-26-2024, 09:15 AM
Replies: 64
Views: 6,512
Posted By Megahurtz
I understand and appreciate it. I just want one...

I understand and appreciate it. I just want one ASAP lol.
Forum: Forced Induction Discussions 04-26-2024, 06:27 AM
Replies: 64
Views: 6,512
Posted By Megahurtz
SAME

SAME
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-26-2024, 06:23 AM
Replies: 16
Views: 1,378
Posted By Megahurtz
Don't have sausage hands. Use your sense of...

Don't have sausage hands. Use your sense of touch. Use the right tools.

They are annoying but easy to swap without removing anything, even with the exhaust still in place.
Forum: ZL1 Parts 04-25-2024, 02:11 PM
Replies: 7
Views: 473
Posted By Megahurtz
OK Thanks, I have someone local to you that would...

OK Thanks, I have someone local to you that would pickup and ship to me.
Forum: ZL1 Parts 04-25-2024, 11:21 AM
Replies: 7
Views: 473
Posted By Megahurtz
can you send picture to jason at...

can you send picture to jason at snackbartuning.com ?
Forum: ZL1 Parts 04-24-2024, 08:04 AM
Replies: 7
Views: 473
Posted By Megahurtz
is it the 2.75" or the 3" version?

is it the 2.75" or the 3" version?
Forum: ZL1 Discussions 04-23-2024, 07:58 AM
Replies: 13
Views: 941
Posted By Megahurtz
Just follow GM's OEM logic. 1st gear shifts 300...

Just follow GM's OEM logic. 1st gear shifts 300 RPM early. 2nd gear shifts 100-200 rpm early. 3-4-5-6-7 shift close to redline.

This is how you go the fastest. Don't overthink it.
Forum: ZL1 Discussions 04-22-2024, 10:35 AM
Replies: 10
Views: 684
Posted By Megahurtz
The gains were all within a dyno error % which is...

The gains were all within a dyno error % which is why I wished he showed the dyno graphs as well. Was the power difference a little "peak" somewhere or was the gains carried through the entire range?...
Forum: ZL1 Discussions 04-22-2024, 08:57 AM
Replies: 10
Views: 684
Posted By Megahurtz
I saw it too, but I wish he shard the dyno graphs...

I saw it too, but I wish he shard the dyno graphs so we could see the whole picture.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 11:07 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.