Homepage Garage Wiki Register Social Groups Calendar Search Today's Posts Mark Forums Read
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


BeckyD @ James Martin Chevy


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.07 seconds. Search: Posts Made By: Techn9cian805
Forum: Transmissions 10-27-2020, 02:09 PM
Replies: 10
Views: 4,574
Posted By Techn9cian805
oops, forgot to update :bonk: The Good:...

oops, forgot to update :bonk:

The Good: Everything lol, it was easy enough to install, and I immediately noticed a difference in feel when sliding from gear to gear, it reduced some of the...
Forum: Suspension / Chassis / Brakes 08-11-2020, 03:13 PM
Replies: 9
Views: 1,588
Posted By Techn9cian805
Front still available?

Front still available?
Forum: Transmissions 08-09-2020, 11:19 AM
Replies: 10
Views: 4,574
Posted By Techn9cian805
I was thinking the same, then i remembered i at...

I was thinking the same, then i remembered i at some point saw someone else on the forums show how they went along all the interior threading with a red paint marker, and I’m going to go ahead and do...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 08-07-2020, 05:22 PM
Replies: 112
Views: 23,933
Posted By Techn9cian805
Yet is the key word. I replaced it in August of...

Yet is the key word. I replaced it in August of last year, and the slow cranks started again about around January when i began to start hitting canyon runs again. Drive it hard a while and see to be...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 08-07-2020, 05:16 PM
Replies: 38
Views: 8,263
Posted By Techn9cian805
I recently installed the MRT 3" piping that comes...

I recently installed the MRT 3" piping that comes with a direct bolt on secondary cat deleting pipe, which made a small difference, definly not something you'll regret doing as the difference isnt...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 08-07-2020, 03:04 PM
Replies: 283
Views: 45,431
Posted By Techn9cian805
I've been away from the forums for a long time,...

I've been away from the forums for a long time, but here's a list in no order of all the problems i've been having.. so far, its living up to the claim..

Starter burned out ( one month after...
Forum: Cosmetic modifications (exterior and interior) 08-07-2020, 02:20 PM
Replies: 83
Views: 31,439
Posted By Techn9cian805
:smiling1: Well... its been a year since this...

:smiling1: Well... its been a year since this thread was last revived, so here i am reviving it again :smiling1:

After reading around about these weighted shifters, and seeing people say it helps...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 08-07-2020, 01:47 PM
Replies: 112
Views: 23,933
Posted By Techn9cian805
I'm on my second starter now. First one died last...

I'm on my second starter now. First one died last year, a month after warranty... i replaced it, but it still has slow cranks, and i notice them happening when driving for long periods, it seems to...
Forum: Transmissions 08-07-2020, 12:22 PM
Replies: 10
Views: 4,574
Posted By Techn9cian805
I love your write up on Raceseng's weighted...

I love your write up on Raceseng's weighted shifters, it was reading this thread that got me to go ahead and pull the trigger on one for my car, I was heavily debating between the Ashiko and Prolix,...
Forum: Tuning / Diagnostics 08-03-2020, 04:35 PM
Replies: 12
Views: 4,770
Posted By Techn9cian805
I haven't been on these forums in a few years...

I haven't been on these forums in a few years lol... and apparently i saved this file last time i was here, i found it here, but can't find the link of the tuner who posted it

EDIT:
...
Forum: Camaro DIY & HOW-TO instructions & discussions 04-15-2019, 11:39 AM
Replies: 3
Views: 1,989
Posted By Techn9cian805
This is pretty awesome!

This is pretty awesome!
Forum: USA - California 03-15-2019, 11:21 AM
Replies: 3
Views: 1,187
Posted By Techn9cian805
DM'd, if still available

DM'd, if still available
Forum: Photos | Videos | Renderings 03-04-2019, 03:09 PM
Replies: 593
Views: 338,346
Posted By Techn9cian805
https://scontent-sjc3-1.cdninstagram.com/vp/16a743...

https://scontent-sjc3-1.cdninstagram.com/vp/16a74369b2ce982119c347d62ab14166/5D23ADA4/t51.2885-15/e35/32503866_474044116382283_7870903190579838976_n.jpg?_nc_ht=scontent-sjc3-1.cdninstagram.com...
Forum: Cosmetic modifications (exterior and interior) 03-04-2019, 03:06 PM
Replies: 52
Views: 13,135
Posted By Techn9cian805
I personally love the clean look without the...

I personally love the clean look without the little red white and blue badging.
...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 02-08-2019, 09:41 AM
Replies: 80
Views: 21,538
Posted By Techn9cian805
I've had mine on that i got from Gen5DIY since...

I've had mine on that i got from Gen5DIY since 2016, and love it. Because of my driving style when just cruising or going about my day, it would always ALWAYS give me the damn skip shift which...
Forum: USA - California 01-03-2019, 12:28 PM
Replies: 5
Views: 1,158
Posted By Techn9cian805
Still available???? I live a few hours north, but...

Still available???? I live a few hours north, but willing to make the drive
Forum: Transmissions 06-18-2018, 10:18 AM
Replies: 5
Views: 1,540
Posted By Techn9cian805
You probably got a bad batch's skip shift. Who...

You probably got a bad batch's skip shift. Who did you buy it from?

I had gotten a skip shift eliminator from a known vendor here in 2016 who's first batch came with the incorrect resistors due...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 06-01-2018, 04:07 PM
Replies: 11
Views: 1,677
Posted By Techn9cian805
You'll definitely have a deeper tone with the...

You'll definitely have a deeper tone with the Flowmaster with its outer Outlaw mufflers which are basically wide straight pipes. It does have a deeper musclecar tone to it, without that fake...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 06-01-2018, 03:22 PM
Replies: 11
Views: 1,677
Posted By Techn9cian805
That or either of the Borla offerings, ATAK or...

That or either of the Borla offerings, ATAK or S-Type, guaranteed drone free.

I do miss my Borla ATAK, which was stolen from my garage when i had taken it off and switched to stock to get an...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-31-2018, 05:17 PM
Replies: 16
Views: 2,720
Posted By Techn9cian805
All the above is correct. Its more than likely...

All the above is correct. Its more than likely just a dirty wheel hub or the lugs arent tightened up to spec. I had the same problem, twice, and took it to the dealership, twice, once they just...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-31-2018, 04:46 PM
Replies: 24
Views: 7,863
Posted By Techn9cian805
It does block 2nd AND 3rd, but does not block 3rd...

It does block 2nd AND 3rd, but does not block 3rd consistently. Sometimes it will still let you in, sometimes it wont unless you wait a split second.

I installed my skip shift eliminator, and...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-29-2018, 05:52 PM
Replies: 31
Views: 17,667
Posted By Techn9cian805
I've heard Flowmaster Outlaw, MBRP, and Magnaflow...

I've heard Flowmaster Outlaw, MBRP, and Magnaflow Race series, in person, and they all sound pretty good... and those are all basically overpriced muffler deletes! So if you paid for either of those...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-29-2018, 09:32 AM
Replies: 31
Views: 17,667
Posted By Techn9cian805
Muffler delete on a v8 = Ricer? What? That's one...

Muffler delete on a v8 = Ricer? What? That's one of the stupidest things i've heard.
Forum: Off-topic Discussions 05-29-2018, 09:26 AM
Replies: 12
Views: 2,467
Posted By Techn9cian805
There shouldn't be anything "happy" about...

There shouldn't be anything "happy" about memorial day...

Thoughts and prayers to all the service men and women that we have lost.
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-25-2018, 02:23 PM
Replies: 26
Views: 6,944
Posted By Techn9cian805
I may be wrong, but i think i remember reading...

I may be wrong, but i think i remember reading that the front was a little taller on the '19, therefore maybe the overall angle of the hood may have a different, slighter slope :iono:
Forum: Off-topic Discussions 05-25-2018, 09:24 AM
Replies: 82
Views: 15,249
Posted By Techn9cian805
Reminds me of one of my favorite lawyer quotes.

Reminds me of one of my favorite lawyer quotes.
Forum: Suspension | Brakes | Chassis 05-11-2018, 10:01 AM
Replies: 27
Views: 6,522
Posted By Techn9cian805
Maybe its morning rust from local humidity...

Maybe its morning rust from local humidity overnight? :iono:
I've already put about 2.3k miles and still nothing, but i also keep my car garaged. I remember what you described used to be an issue...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-04-2018, 01:54 PM
Replies: 30
Views: 6,944
Posted By Techn9cian805
I can't speak on the S Type, but i have...

I can't speak on the S Type, but i have absolutely no drone with my Borla Atak. It is really quiet inside. Borla promises drone-free exhausts for the 6th gen, and from the many others who have them...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-04-2018, 11:47 AM
Replies: 41
Views: 10,847
Posted By Techn9cian805
Everyone's sensitivity to drone is different, but...

Everyone's sensitivity to drone is different, but if you want truly drone free, consider Borla. But... like i've mentioned, i've been inside my friend's car several times, and he's running the NPP...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-03-2018, 11:54 AM
Replies: 41
Views: 10,847
Posted By Techn9cian805
Really? is it the NPP version or dual tip outlaw...

Really? is it the NPP version or dual tip outlaw axleback? I've been inside cars with magnaflow competition and flowmaster american thunder axlebacks, and the flowmaster didn't have any drone...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 02:20 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.