Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Page 1 of 4 1 234
Showing results 1 to 30 of 112
Search took 0.02 seconds. Search: Posts Made By: wanab
Forum: ZL1 Discussions 03-19-2020, 08:34 PM
Replies: 14
Views: 2,833
Posted By wanab
I'm lightly modded so I think that bodes well for...

I'm lightly modded so I think that bodes well for the cats.

• Mamo 87 mm ported throttle body
• Roto-Fab cold air intake
• Kooks long tube headers (2” primaries)
o Jet-Hot coated
• Kooks high...
Forum: ZL1 Discussions 03-19-2020, 05:45 PM
Replies: 61
Views: 26,902
Posted By wanab
My 2yr old copy did the same thing but they have...

My 2yr old copy did the same thing but they have drivers on their web site that made mine work with the new Adobe Reader DC. (except for the search feature).
Forum: ZL1 Discussions 03-19-2020, 05:31 PM
Replies: 14
Views: 2,833
Posted By wanab
Mine have had a season of drag racing with no...

Mine have had a season of drag racing with no codes. I think the demands of a road course would be much more tough on them but don't really know. Had a bung for a wide band welded into the front...
Forum: ZL1 Discussions 03-19-2020, 08:39 AM
Replies: 14
Views: 2,833
Posted By wanab
Also had the headers Jet Hot coated. Shipped...

Also had the headers Jet Hot coated. Shipped straight to Jet Hot by Kooks.
Forum: ZL1 Discussions 03-18-2020, 09:05 PM
Replies: 14
Views: 2,833
Posted By wanab
Did mine last winter (year ago) with race ramps...

Did mine last winter (year ago) with race ramps and jackstands in the garage. Kooks w/2" primaries. Had most trouble with passenger side because I didn't recognize the aluminum brace could be...
Forum: ZL1 Discussions 02-23-2020, 02:59 PM
Replies: 23
Views: 3,693
Posted By wanab
I installed Kook's 2" w/high flow green cats and...

I installed Kook's 2" w/high flow green cats and Kook's 3" X pipe to the rear suitcase muffler. The cut to the stock exhaust was dictated by where the 3" Kook's X pipe ended which was just in front...
Forum: ZL1 Discussions 07-10-2019, 08:59 AM
Replies: 7
Views: 938
Posted By wanab
Do these builds usually require injectors at the...

Do these builds usually require injectors at the described power levels? Also interested in fuel and meth for these builds.
Forum: ZL1 Discussions 07-10-2019, 08:53 AM
Replies: 7
Views: 938
Posted By wanab
My mods and tune only pushed me up about 70 -90...

My mods and tune only pushed me up about 70 -90 HP. The tune was done by a nationally know shop (not local guru) and I have not had any problems yet. I did do the 1LE solid rear cradle bushing and...
Forum: ZL1 Discussions 07-10-2019, 08:45 AM
Replies: 7
Views: 938
Posted By wanab
Can you post a link. Id like to take a look at...

Can you post a link. Id like to take a look at that.
Forum: ZL1 Discussions 07-10-2019, 08:23 AM
Replies: 7
Views: 938
Posted By wanab
I think they are making their power with cams,...

I think they are making their power with cams, headers, head work, and lots of extra timing allowed by the full E85. We have a blower forcing more air and must provide the extra fuel to go with that...
Forum: ZL1 Discussions 06-18-2019, 03:28 PM
Replies: 20
Views: 4,464
Posted By wanab
I have a 24' V nose without a side door. I am...

I have a 24' V nose without a side door. I am 220 lbs 5' 10" and I open my door to a piece of carpet on the interior of the trailer wall, put the driver window down, and recline the drivers seat all...
Forum: ZL1 Discussions 05-28-2019, 03:05 PM
Replies: 88
Views: 17,778
Posted By wanab
My car is bolt on. RotoFab, kooks/2" primaries...

My car is bolt on. RotoFab, kooks/2" primaries and green cats, kooks 3" x-pipe and mid pipe to stock muffler, Mamo PTB, JMS low side fuel pump voltage booster, DSX flex fuel kit.

No pulley.

Car...
Forum: ZL1 Discussions 05-28-2019, 02:42 PM
Replies: 88
Views: 17,778
Posted By wanab
The flex fuel sensor reports the ethanol content...

The flex fuel sensor reports the ethanol content and Ted tells the computer what to do based on the reported content.
Forum: ZL1 Discussions 05-28-2019, 02:35 PM
Replies: 88
Views: 17,778
Posted By wanab
Just like you said. The magic is in the tuner.

Just like you said. The magic is in the tuner.
Forum: ZL1 Discussions 05-28-2019, 02:33 PM
Replies: 88
Views: 17,778
Posted By wanab
I just keep a 5 gallon can of each and if I need...

I just keep a 5 gallon can of each and if I need to correct i'll just add for the direction I need to go. I had been doing all of this in the garage but decided to take my formula to the pump and...
Forum: ZL1 Discussions 05-28-2019, 01:39 PM
Replies: 88
Views: 17,778
Posted By wanab
I started with a cheap Holly ethanol % tester but...

I started with a cheap Holly ethanol % tester but have evolved to making a best guess based on gas gauge and how much I want to brew. I have a spread sheet formula that will tell me how much of each...
Forum: ZL1 Discussions 05-28-2019, 10:51 AM
Replies: 88
Views: 17,778
Posted By wanab
Ted and KingLT1, Thanks for the good replies.

Ted and KingLT1,

Thanks for the good replies.
Forum: ZL1 Discussions 05-27-2019, 06:49 PM
Replies: 88
Views: 17,778
Posted By wanab
fuel used to cut the e85

Ted,

I am using 91 octane to cut my e85. How critical is the choice of fuel used to cut the e85. Am I leaving a ton on the table?

Does the octane rating of the cutting fuel show up in your...
Forum: Dragstrip and Launching Discussion 05-13-2019, 10:03 AM
Replies: 2,409
Views: 869,419
Posted By wanab
Tires used on the pass:M/T Street R P305/45R17 ...

Tires used on the pass:M/T Street R P305/45R17
Performance Mods (if any): LT, Exhaust, PTB, CAI, DR, FFK-FlexFuel Kit, E40, FPVB, Low side fuel pump voltage booster, TUNE
Category submitted for:...
Forum: ZL1 Discussions 01-01-2019, 01:05 PM
Replies: 188
Views: 33,848
Posted By wanab
Bolt on questions

Ted,
I would like to ask a couple questions on a bolt on plan for my 2017 a10 coupe

DSX FlexFuel sensor kit

RotoFab CAI

Mamo Motorsports stock size ported throttle body

Long tube...
Forum: ZL1 Parts 09-28-2018, 05:10 PM
Replies: 0
Views: 862
Posted By wanab
sold

Sold
Forum: Suspension | Brakes | Chassis 09-24-2018, 09:14 AM
Replies: 201
Views: 47,253
Posted By wanab
Travis, Thanks for the thread. I don't...

Travis,

Thanks for the thread. I don't track my ZL1 but I do strip it. I had ordered my parts (GM solid rear cradle bushings and BMR solid differential bushings) before I found your thread but I...
Forum: Dragstrip and Launching Discussion 05-07-2018, 07:48 AM
Replies: 2,409
Views: 869,419
Posted By wanab
Tires used on the pass: Factory Goodyears ...

Tires used on the pass: Factory Goodyears
Performance Mods (if any): none
Category submitted for: Please List the Category or Category # 7
R/T.......... -.079
60'............. 1.867...
Forum: ZL1 Discussions 04-26-2018, 03:48 PM
Replies: 23
Views: 3,715
Posted By wanab
Big Dave, You are a lucky man as I have a...

Big Dave,

You are a lucky man as I have a much more serious case of the same affliction. I had the dealership apply "some kind of paint treatment" when I bought the car but in the year I have...
Forum: ZL1 Discussions 02-03-2018, 09:47 AM
Replies: 0
Views: 807
Posted By wanab
deleted

deleted
Forum: ZL1 Discussions 01-08-2018, 07:15 PM
Replies: 8
Views: 1,569
Posted By wanab
Mine was purchased from the Chevrolet dealership...

Mine was purchased from the Chevrolet dealership where I bought my ZL1. Any GM dealership should be able to order you one.
Forum: ZL1 Discussions 01-07-2018, 05:39 PM
Replies: 8
Views: 1,569
Posted By wanab
Mine did. It is my understanding that all ZL1...

Mine did. It is my understanding that all ZL1 splitters are Mosaic Black Metallic so mine came painted.
Forum: ZL1 Discussions 09-26-2017, 02:00 PM
Replies: 12
Views: 3,904
Posted By wanab
For the A10 lurkers, I thought mine was screwed...

For the A10 lurkers, I thought mine was screwed up but I found out my car won't perform well with a 2300 stall. At that level when I release the brake it sneezes, farts, coughs, and then takes off...
Forum: Ask the Camaro Team 09-25-2017, 06:30 PM
Replies: 17
Views: 6,048
Posted By wanab
Lock launch control settings as your personal...

Lock launch control settings as your personal default.
Forum: Ask the Camaro Team 09-25-2017, 05:51 PM
Replies: 1
Views: 2,225
Posted By wanab
10.95 recipe

Please prod the engineers to release the recipe for 10.95 second 1/4 mile passes. They had to have worked very hard to select all of the correct modes, settings within those modes, tire pressures,...
Showing results 1 to 30 of 112
Page 1 of 4 1 234

 
Forum Jump

All times are GMT -5. The time now is 03:25 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.