Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


AWE Tuning


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.14 seconds. Search: Posts Made By: radz28
Forum: Forced Induction Discussions Today, 11:29 AM
Replies: 4
Views: 48
Posted By radz28
It seems you're on track with those Toyos. It...

It seems you're on track with those Toyos. It sounds like if you wanted to run on the OEM wheels, you could also try the 20" MT ET SSs, too. I've heard those are pretty good. Maybe some DRs on the...
Forum: ZL1 Discussions Today, 11:23 AM
Replies: 7
Views: 221
Posted By radz28
I don't drive my car often, but when I do, it's...

I don't drive my car often, but when I do, it's pretty hard. My oil always times-out (I use the oil life monitor), rather than from mileage or anything. After almost 5-years of ownership, I have...
Forum: ZL1 Discussions Today, 11:16 AM
Replies: 38
Views: 6,084
Posted By radz28
My car is a '20, but built in 07/19 (purchased...

My car is a '20, but built in 07/19 (purchased the end of that September).

I'm still on the original battery, but have had it on an Optima trickle since about 11/19, because when I connected it...
Forum: Forced Induction Discussions 04-26-2024, 10:00 AM
Replies: 10
Views: 291
Posted By radz28
I didn't change my shift points. I'm running a...

I didn't change my shift points. I'm running a slightly smaller upper for a couple more pounds, and am positive power doesn't peak (boost doesn't drop-off at all at redline and above), but I don't...
Forum: ZL1 Discussions 04-26-2024, 06:59 AM
Replies: 26
Views: 915
Posted By radz28
I've had my issues with Corsa, and Borla on other...

I've had my issues with Corsa, and Borla on other cars.

On my 4th Gens, both my catbacks' tips were out of alignment. They replaced them, pretty much no questions asked, but BOTH had that...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-26-2024, 06:49 AM
Replies: 16
Views: 942
Posted By radz28
This. I didn't remove anything. It wasn't...

This.

I didn't remove anything. It wasn't convenient, and couldn't see what I was doing while doing it, but the right tool, as stated, made it quick.

Worth it.
Forum: Tuning / Diagnostics 04-25-2024, 10:44 AM
Replies: 17
Views: 777
Posted By radz28
:happy0180: My initial tuner did it that way,...

:happy0180: My initial tuner did it that way, and leaves a good amount of TM in there. From what I've seen, what he commanded wasn't out of line, and I haven't messed with it. I feel good about it...
Forum: Tuning / Diagnostics 04-25-2024, 08:14 AM
Replies: 17
Views: 777
Posted By radz28
I agree. But that's how people were getting...

I agree. But that's how people were getting around TM when T93s were still locked is all I'm saying. I can say that it helped though (though - maybe at the expense of tranny life if gone too far).
Forum: ZL1 Discussions 04-25-2024, 08:12 AM
Replies: 18
Views: 792
Posted By radz28
I believe the blower mounting bolts are TTY. The...

I believe the blower mounting bolts are TTY. The seals are probably fine (I think there are 5, total).
Forum: Tuning / Diagnostics 04-25-2024, 06:58 AM
Replies: 17
Views: 777
Posted By radz28
I had a BIG TM hit on the 2-3 shift if I recall...

I had a BIG TM hit on the 2-3 shift if I recall before tuning it out. Heck - I'm positive I can hear it on newer cars, like the Escalade V (I don't think I've seen videos with the CT5-V doing a 2-3...
Forum: ZL1 Discussions 04-25-2024, 06:55 AM
Replies: 18
Views: 792
Posted By radz28
Samesies. I can reach mine easier with the PI...

Samesies. I can reach mine easier with the PI plates installed, but I think you'd still have to either remove the snout or lift the blower to access the valve. The snout's a PITA because of a...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-25-2024, 06:49 AM
Replies: 92
Views: 5,203
Posted By radz28
This makes sense in my head :happy0180:

This makes sense in my head :happy0180:
Forum: ZL1 Discussions 04-22-2024, 11:15 AM
Replies: 10
Views: 591
Posted By radz28
The next test should be a good one, wherein...

The next test should be a good one, wherein airflow will really be tested.

LMP showed an A to B test if I recall, which was pretty surprising. RPM, for years, insisted there was no difference in...
Forum: ZL1 Discussions 04-22-2024, 10:26 AM
Replies: 10
Views: 591
Posted By radz28
THPSI and DSX make billet lids for Maggie 2650s

THPSI and DSX make billet lids for Maggie 2650s
Forum: Camaro DIY & HOW-TO instructions & discussions 04-20-2024, 09:42 PM
Replies: 1
Views: 343
Posted By radz28
KUDOS AND THANKS!!!

KUDOS AND THANKS!!!
Forum: ZL1 Discussions 04-20-2024, 09:39 PM
Replies: 18
Views: 944
Posted By radz28
Picked up A LITTLE more whine and is harmless. ...

Picked up A LITTLE more whine and is harmless. I'd do it again.
Forum: ZL1 Discussions 04-19-2024, 11:19 AM
Replies: 67
Views: 6,324
Posted By radz28
I updated my crazy THPSI-thread, but I'll...

I updated my crazy THPSI-thread, but I'll truncate an answer here, too:

Yes. It was my fault, I'm fairly certain.

It seems to be working as you would expect - completely fine. I'm reading a...
Forum: Forced Induction Discussions 04-19-2024, 11:02 AM
Replies: 191
Views: 26,482
Posted By radz28
I would like to accept credit, but I think it's...

I would like to accept credit, but I think it's more my OCD, lol.

I believe the OEMs get pretty much all of it right, but I also recognize they have to work within a lot of constraints, and that's...
Forum: ZL1 Discussions 04-18-2024, 11:31 AM
Replies: 12
Views: 757
Posted By radz28
The injectors referenced above might be the...

The injectors referenced above might be the Escalade V injectors, which flow a little more, but are physically smaller.
Forum: ZL1 Discussions 04-17-2024, 01:58 PM
Replies: 336
Views: 47,589
Posted By radz28
I just installed my Katech module and love it. I...

I just installed my Katech module and love it. I think my THPSI system, with the current injectors, is good to the same power level your bucket supports, and since I'm running the OEM feed line, and...
Forum: Tuning / Diagnostics 04-17-2024, 12:00 PM
Replies: 37
Views: 1,680
Posted By radz28
JSH - IMHO - just let a calibrator get this done...

JSH - IMHO - just let a calibrator get this done for you. There are 2 that always try to help, and JRE jumps in, too.
Forum: ZL1 Discussions 04-17-2024, 11:57 AM
Replies: 226
Views: 32,041
Posted By radz28
Bad influence... ...

Bad influence... :laughabove::happy0180::respekt::bow:
Forum: ZL1 Discussions 04-17-2024, 11:54 AM
Replies: 336
Views: 47,589
Posted By radz28
SWEET!!! Katech are top tier of the LS/LT game. ...

SWEET!!! Katech are top tier of the LS/LT game.

Are you guys doing fuel lines from front to rear?
Forum: Tuning / Diagnostics 04-16-2024, 01:11 PM
Replies: 37
Views: 1,680
Posted By radz28
Ben Charles posted that like 10-years ago, lol. ...

Ben Charles posted that like 10-years ago, lol. He helped me on my tune early on, and it ran GREAT. That graphic might be specific for the cam he was doing these SOI/EOI tests on though. Just be...
Forum: ZL1 Discussions 04-16-2024, 10:48 AM
Replies: 77
Views: 11,973
Posted By radz28
I haven't downloaded the latest software, but it...

I haven't downloaded the latest software, but it makes no mention of it, but - about 2-years ago, someone said their engineering team said that it wouldn't be added because there wasn't enough room,...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-12-2024, 12:53 PM
Replies: 3
Views: 514
Posted By radz28
DO THIS

DO THIS
Forum: ZL1 Discussions 04-11-2024, 11:33 AM
Replies: 14
Views: 871
Posted By radz28
DSX is coming to market, soon, with their own PI...

DSX is coming to market, soon, with their own PI and controller, that doesn't require any of the cheating that everything else out there does (I have heard it won't be the only option, but I don't...
Forum: Tuning / Diagnostics 04-11-2024, 07:34 AM
Replies: 37
Views: 1,680
Posted By radz28
I thought you said your rail pressure was...

I thought you said your rail pressure was dropping... My bad.

If I recall the last tuner, then I'm sure the SOI was set-up for the last combination perfectly fine. If it's at 380*, it's higher...
Forum: ZL1 Discussions 04-11-2024, 07:24 AM
Replies: 14
Views: 871
Posted By radz28
No biggie! I just didn't want to come across as...

No biggie! I just didn't want to come across as a know-it-all-jerk :happy0180:

There are some guys who've been in the game a long time that have taken a stock LT4 (I think valves prings, too)to...
Forum: Tuning / Diagnostics 04-10-2024, 02:40 PM
Replies: 37
Views: 1,680
Posted By radz28
There's an alcohol modifier, too, that might...

There's an alcohol modifier, too, that might influence this, if it's been changed. I think my stock tune was adding up to 15* for alcohol. I say this because if your tuner changed this (or others...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 12:30 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.