Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


BeckyD @ James Martin Chevy


Showing results 1 to 12 of 12
Search took 0.01 seconds. Search: Posts Made By: amoreno73
Forum: 4th Generation Camaros 02-27-2016, 05:42 PM
Replies: 27
Views: 29,502
Posted By amoreno73
rebuild using copart

If there is a number of items that needs to be replaced in order to convert from a v6 to v8 why not just get a completely totaled car from copart and swap everything into your V6 Camaro. At least you...
Forum: Cosmetics and Lighting Modification Discussions 02-22-2016, 12:45 PM
Replies: 31
Views: 13,843
Posted By amoreno73
Smile It is now under a recall

I had mine replaced just recently and before that received a recall notification in the mail.:thanks:
Forum: 5th Gen Camaro SS LS LT General Discussions 03-22-2015, 01:42 PM
Replies: 46
Views: 43,691
Posted By amoreno73
Here is an idea

I would figure get a wrecked SS or ZL1 from copart.com and swap components from the wrecked Camaro to your V6 Camaro. The catch is the highest bid is going for at least 7 grand.

:noidea:
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 12-20-2014, 09:16 PM
Replies: 93
Views: 31,839
Posted By amoreno73
Emissions legal?

I live in California my car has 99500 miles and now have slight rough idle and found out my catalytic converter in the drivers side needs to be replaced. The dealer says it is out of warranty and...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-10-2014, 06:44 PM
Replies: 46
Views: 43,691
Posted By amoreno73
Take the risk.

I would figure no one have tried it. I would figure swap the engine only and mate it to the V6's original transmission, you will have to replace the drive shaft also. This is a experimental engine...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-06-2014, 01:53 AM
Replies: 46
Views: 43,691
Posted By amoreno73
Rebuild a wrecked 5th gen

The problem is parts. You have to start with a series of parts at the same time. I would figure you have to get a complete engine, transmission, rear axle, driveshaft, and radiator all at once, then...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-09-2014, 02:40 AM
Replies: 47
Views: 11,443
Posted By amoreno73
Why not use a wrecked Camaro?

I checked copart.com and found several wrecked 5th Gen Camaro SS and at least a ZL1. Could you pull all the parts you need from the wrecked Camaro and put them in a used 2010 Camaro V6?

:headbang:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 06-02-2014, 01:42 PM
Replies: 1,132
Views: 351,845
Posted By amoreno73
There are better alternatives

The idea of the turbo four is at during cruising speed of 70 to 80 the turbo is not used and you can get 35 to 40 mpg. You can get the same results if you had a 6cyl 320hp with cylinder...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 06-02-2014, 01:35 PM
Replies: 72
Views: 45,159
Posted By amoreno73
Here is my best guess and only a guess

V6 3.8: all 1LS, 2LS, 1LT, 2LT
V6 3.0 twin turbo: RS only
V8 LT1: 1SS and 2SS
Z/28 and ZL1 will not be made 1 or 2 years after initial 6th gen release depending they plan to recycle the LS7 or LS9...
Forum: 5th Gen Camaro SS LS LT General Discussions 02-21-2012, 07:10 PM
Replies: 167
Views: 13,611
Posted By amoreno73
I would not know. I drive the v6 version and all...

I would not know. I drive the v6 version and all I need is 87 octane. I found out two websites that have a module that bypasses the fuel injectors and allow any car to run on E85. They are: ...
Forum: Suspension / Brakes / Chassis 02-21-2012, 07:02 PM
Replies: 7
Views: 2,794
Posted By amoreno73
Depends on cost

I would go for 20." You would have to think of long term cost. When you have to replace the rubber on the 20" is a lot cheaper than tires for a 22" rim.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 02-24-2011, 03:09 PM
Replies: 85
Views: 13,335
Posted By amoreno73
wrong steering wheel

The current steering wheel is not bad. Why can't just fix the current one instead of using one from a Cruze. All they need to do is modify the horizonal bars that hold the wheel side to side. Either...
Showing results 1 to 12 of 12

 
Forum Jump

All times are GMT -5. The time now is 09:42 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.