Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums


AWE Tuning


Showing results 1 to 30 of 500
Search took 0.08 seconds.
Search: Posts Made By: FasNuf
Forum: Tuning / Diagnostics -- engine and transmission Today, 09:41 AM
Replies: 19
Views: 319
Posted By FasNuf
I agree here Jeff. Usually +/- 25 will give a...

I agree here Jeff. Usually +/- 25 will give a code but it's hard to know what's turned off in your tune.
After you swap the O2's if you can reset your fuel trims, that would speed the results a bit....
Forum: Tuning / Diagnostics -- engine and transmission Yesterday, 10:35 PM
Replies: 19
Views: 319
Posted By FasNuf
Not sure if it would matter, but I'd use the same...

Not sure if it would matter, but I'd use the same brand that you currently have just in case there might be a difference in others that would affect your tune.
Forum: Tuning / Diagnostics -- engine and transmission Yesterday, 07:34 PM
Replies: 19
Views: 319
Posted By FasNuf
Well it’s a good way to see if it’s the O2...

Well it’s a good way to see if it’s the O2 sensor. The short terms are reading nice because they already transferred the error they saw earlier to the long terms.
My hernia doesn’t let me crawl too...
Forum: Tuning / Diagnostics -- engine and transmission Yesterday, 07:19 PM
Replies: 19
Views: 319
Posted By FasNuf
Swap the sensors and see if it follows to the...

Swap the sensors and see if it follows to the other bank.
Forum: Tuning / Diagnostics -- engine and transmission Yesterday, 05:50 PM
Replies: 19
Views: 319
Posted By FasNuf
Any codes?

Any codes?
Forum: 5th Gen Camaro SS LS LT General Discussions 05-30-2024, 10:13 AM
Replies: 16
Views: 720
Posted By FasNuf
I think GM should've dropped the LT# / A10 into...

I think GM should've dropped the LT# / A10 into the Gen5 body style for a couple years before going to the 6th gen body. Maybe they could've stretched out the sales a while longer that way.
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 05-29-2024, 07:49 PM
Replies: 10
Views: 420
Posted By FasNuf
Yep, like sandpaper then.

Yep, like sandpaper then.
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 05-27-2024, 09:10 PM
Replies: 10
Views: 420
Posted By FasNuf
Whatever cover you decide, make sure it protects...

Whatever cover you decide, make sure it protects the paint. My cover fit very tight, but after a few times of having it on and the wind battering the cover against the car, I noticed some scratching...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-27-2024, 12:10 AM
Replies: 30
Views: 1,061
Posted By FasNuf
No, I don't think the ECM is controlling that and...

No, I don't think the ECM is controlling that and I also don't think the first time you ran it dry it would kill the pump either. Pretty sure GM didnt see a need to invest the time to make it do...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2024, 08:46 PM
Replies: 30
Views: 1,061
Posted By FasNuf
I suppose it depends if you mean the OEM pump. I...

I suppose it depends if you mean the OEM pump. I guess the fuel pressure sensor would see the drop in pressure and kick the pump on , but if it's sucking air the engine would quit. I imagine the ECM...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2024, 04:06 PM
Replies: 30
Views: 1,061
Posted By FasNuf
I just put Stabil in my gas before storing the...

I just put Stabil in my gas before storing the car for the winter.

Most OEM fuel pumps now are PWM, meaning they are computer controlled to only run enough to keep rail pressure up so they don't...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-26-2024, 03:56 PM
Replies: 30
Views: 1,061
Posted By FasNuf
Gen 5 tanks are poly so they won’t corrode.

Gen 5 tanks are poly so they won’t corrode.
Forum: Cosmetic Maintenance: Washing, Waxing, Detailing, Bodywork, Protection 05-19-2024, 10:09 AM
Replies: 18
Views: 3,476
Posted By FasNuf
Only thing I would add to the above method is...

Only thing I would add to the above method is rinsing with a good DI water. This makes for a spot free rinse. The DI filter removes all the solids from the water. I needed this because my water is so...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-18-2024, 04:04 PM
Replies: 30
Views: 1,061
Posted By FasNuf
Yea I believe it would. Seriously though if you...

Yea I believe it would. Seriously though if you have crap in your fuel then it’s time to service the tank.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-18-2024, 03:58 PM
Replies: 30
Views: 1,061
Posted By FasNuf
https://youtu.be/p8hW5ShKJ5Q?si=kWmMK7fcUnbekN9X ...

https://youtu.be/p8hW5ShKJ5Q?si=kWmMK7fcUnbekN9X

No cooling is not 100% when there isn’t much fuel in the tank. The pumps will heat the fuel and if there’s a lot of fuel, then there is a lot of...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-17-2024, 09:40 PM
Replies: 30
Views: 1,061
Posted By FasNuf
Our tanks actually have two sides, one on each...

Our tanks actually have two sides, one on each side of the driveshaft tunnel. Theres a tube that goes from the drivers side over to the passenger side where the fuel pump is located inside a bucket....
Forum: 5th Gen Camaro SS LS LT General Discussions 05-17-2024, 12:07 PM
Replies: 30
Views: 1,061
Posted By FasNuf
That’s not how my OEM pump and tank was but maybe...

That’s not how my OEM pump and tank was but maybe the SS is different.:noidea::noidea:
Forum: 5th Gen Camaro SS LS LT General Discussions 05-17-2024, 09:12 AM
Replies: 30
Views: 1,061
Posted By FasNuf
The question is what kind of pump is the OP...

The question is what kind of pump is the OP talking about? OEM has a fuel bucket so the pumps are always submerged in fuel until the tank is empty. This applies also to the Deatschwerks pump like I'm...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-05-2024, 04:10 PM
Replies: 10
Views: 467
Posted By FasNuf
You're welcome. I'd power the pump directly...

You're welcome.
I'd power the pump directly seems like a safer option than jumping the remote.
What color wire is on your remote?
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-05-2024, 03:53 PM
Replies: 10
Views: 467
Posted By FasNuf
Powering the remote is what connects the big...

Powering the remote is what connects the big power through the relay to your pump, but I'd be careful not to backfeed the car and dont run your pump dry.
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-05-2024, 03:37 PM
Replies: 10
Views: 467
Posted By FasNuf
I see, that would work since you're mindful of...

I see, that would work since you're mindful of the overheat possibilities. You could power the pump directly with a 12 volt battery provided you knew which wires to connect to.

Looks like to me...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-05-2024, 02:58 PM
Replies: 10
Views: 467
Posted By FasNuf
Is there a fuel door under the back seat to get...

Is there a fuel door under the back seat to get to the fuel pump?
Also running your fuel pumps to drain the tank will probably over heat the pumps causing failure.
If you don't have an access door...
Forum: ZL1 Parts 04-28-2024, 01:29 PM
Replies: 0
Views: 310
Posted By FasNuf
2014 ZL1 sway bars for sale $200 for set.

Good used set. Had 25,000 miles when removed.
$200 for both as shown, but won't ship. ( sorry )
Located near Salem Oregon.
Forum: Engine | Exhaust | Bolt-On | Drivetrain Modifications 04-27-2024, 07:21 PM
Replies: 5
Views: 713
Posted By FasNuf
It's a 10 amp under the right side cover in the...

It's a 10 amp under the right side cover in the trunk.

If you're interested later, you can put a 3 way switch in to allow control of the valves.

This might help....
...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-26-2024, 09:01 PM
Replies: 8
Views: 416
Posted By FasNuf
Yea, I was just curious on the moly. I figured...

Yea, I was just curious on the moly. I figured it was an additive or something.
Nothing in yourt pleats is a good sign. Probably just cylinder wall wear as said previously.

I had an oil lab tell...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-26-2024, 08:42 PM
Replies: 8
Views: 416
Posted By FasNuf
Iron doesnt seem out of line. I'm curious why you...

Iron doesnt seem out of line. I'm curious why you have so much moly though.
I use a filter cutter and inspect my pleats as part of my sample routine.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-25-2024, 06:31 PM
Replies: 34
Views: 1,726
Posted By FasNuf
EDITED: The EXECUTIONER from TSP is a re-sleeved...

EDITED: The EXECUTIONER from TSP is a re-sleeved LS3 block punched to 427
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-25-2024, 12:02 AM
Replies: 34
Views: 1,726
Posted By FasNuf
It’s a Dynajet

It’s a Dynajet
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-24-2024, 09:16 AM
Replies: 34
Views: 1,726
Posted By FasNuf
I would be interested to know if your clutch is...

I would be interested to know if your clutch is fully broke in and also what the dyno would say if correction was set to SAE. McLeod recommends something like 1500 clutch cycles and no reference to...
Forum: Member Car Journals 04-24-2024, 06:33 AM
Replies: 222
Views: 146,212
Posted By FasNuf
Looks great Vic! Tons of hard work in that beauty.

Looks great Vic! Tons of hard work in that beauty.
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 04:23 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.