Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums


Phastek Performance


Showing results 1 to 30 of 500
Search took 0.08 seconds.
Search: Posts Made By: Jeff_SS
Forum: Suspension / Brakes / Chassis Yesterday, 11:44 PM
Replies: 18
Views: 2,177
Posted By Jeff_SS
Just bought individually off Summit

Just bought individually off Summit
Forum: 5th Gen Camaro SS LS LT General Discussions 09-14-2024, 11:14 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Finally buttoned up the rear end suspension. ...

Finally buttoned up the rear end suspension.
Installed Bilstein B6's in the rear. Disassembled some suspension pieces and cleaned up and painted and re-torqued them.

While I was doing that I also...
Forum: Suspension / Brakes / Chassis 09-14-2024, 11:11 PM
Replies: 18
Views: 2,177
Posted By Jeff_SS
Finished up installing both rear bilstein B6's....

Finished up installing both rear bilstein B6's. Didn't use GM factory bump stops. Feels great. Very smooth and firm in the right way when going over speed bumps or dips in the road - no suspension...
Forum: Suspension / Brakes / Chassis 09-14-2024, 12:37 AM
Replies: 18
Views: 2,177
Posted By Jeff_SS
Installed driver rear. There was no bump stop...

Installed driver rear. There was no bump stop that needed to be transferred from the factory strut.
Must only be on the fronts.
Going to do the passenger rear tomorrow.

EDIT: doing passenger...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-13-2024, 02:40 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Replaced driver side rear strut with a new B6 and...

Replaced driver side rear strut with a new B6 and also replaced the axle seal.
The lower coil spring insulator (GM PN: 92232063) was completely worn. But apparently GM discontinued them, like...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-06-2024, 09:42 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Went to pull the axles to replace the axle seals...

Went to pull the axles to replace the axle seals on the diff and put in my new rear struts. Axle nut was seized on. Tried removing with a big breaker bar. Then used a big pipe to get more leverage,...
Forum: Suspension / Brakes / Chassis 09-01-2024, 08:28 PM
Replies: 18
Views: 2,177
Posted By Jeff_SS
Please respond. Bought these and hoping to...

Please respond.

Bought these and hoping to install this week/weekend.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-31-2024, 10:25 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Decided to take off the LCAs and clean them up a...

Decided to take off the LCAs and clean them up a bit. Tired of looking at the surface rust on them and how bad they looked after like 12 years.

Next week I’ll be changing the rear struts and diff...
Forum: Suspension / Brakes / Chassis 08-29-2024, 10:55 AM
Replies: 18
Views: 2,177
Posted By Jeff_SS
x3 curious as well. About to pull the trigger on...

x3 curious as well. About to pull the trigger on some B6's in the next week or so. with 1.25" pfadt drop springs. I think I remember when installing the pfadt springs on the stock struts I cut half...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-24-2024, 04:34 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Climbed underneath her this afternoon trying to...

Climbed underneath her this afternoon trying to chase down the rear suspension clunking noise I'm having (https://www.camaro5.com/forums/showthread.php?p=11283163#post11283163) and noticed a little...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-22-2024, 09:58 PM
Replies: 34
Views: 7,992
Posted By Jeff_SS
Still trying to track this issue down. I'm...

Still trying to track this issue down. I'm wondering if maybe it's the factory struts finally going out? Should I buy Bilstein B6's?
Wouldn't know where to start if it's bushings..

Any more...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-22-2024, 05:35 PM
Replies: 37
Views: 1,845
Posted By Jeff_SS
Time to make a dr appointment to get your neck...

Time to make a dr appointment to get your neck and back pain checked. I'd also sue the insurance company for depreciated value after that accident now will be on your VIN forever.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-10-2024, 05:40 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
This morning I took the time to vacuum the...

This morning I took the time to vacuum the system, replace the thermostatic expansion valve and recharge the system. Really wasn’t too bad replacing the expansion valve with the right 3/8”...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 08-10-2024, 05:35 PM
Replies: 3
Views: 471
Posted By Jeff_SS
Well I took the time to vacuum the system,...

Well I took the time to vacuum the system, replace the thermostatic expansion valve and recharge the system. Really wasn’t too bad replacing the expansion valve with the right 3/8” extensions.
...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-06-2024, 11:18 AM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Good to hear this was your result. Hope I have...

Good to hear this was your result. Hope I have the same experience after I swap it out. Looks like a pain to reach up in there but I'll figure it out.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 08-05-2024, 10:35 PM
Replies: 3
Views: 471
Posted By Jeff_SS
Makes sense. So I'll have to pull everything out...

Makes sense. So I'll have to pull everything out of the system, replace the expansion valve, and then fully recharge the system again.
Hope that works.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-05-2024, 03:37 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Finally gave up and took it to an A/C shop to...

Finally gave up and took it to an A/C shop to have them diagnose the issue with it not blowing cold air after trying a ton of things myself.
Made a thread about it here...
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 08-05-2024, 03:22 PM
Replies: 3
Views: 471
Posted By Jeff_SS
A/C Problems. Replace Expansion Valve?

Been chasing an A/C issue with my Camaro like many of us have. Air doesn't blow cold.

Initially I thought blend door based on the popularity of that issue. Took apart everything underneath to find...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 06-16-2024, 10:19 PM
Replies: 5
Views: 682
Posted By Jeff_SS
Very nice. 135mph is moving. And that backdrop...

Very nice. 135mph is moving.
And that backdrop is incredible.
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 06-04-2024, 11:02 PM
Replies: 4
Views: 1,959
Posted By Jeff_SS
As many a/c problems that these cars have and...

As many a/c problems that these cars have and that I've read about on here, apparently these service valves are a huge weak point that leak very often.
Make sure your system is empty then change the...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-27-2024, 10:11 PM
Replies: 14
Views: 1,143
Posted By Jeff_SS
I just bought a new service valve and the socket...

I just bought a new service valve and the socket to remove it. Guess I'll try that this weekend. Willing to try everything at this point after everything I've been through with this...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-25-2024, 08:23 PM
Replies: 14
Views: 1,143
Posted By Jeff_SS
I'm in the same boat. I bought a replacement...

I'm in the same boat. I bought a replacement blend door and the morning I went to start taking things apart I decided to remove the blend door motor and look inside and sure enough the whole door was...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-03-2024, 06:17 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
I did the same thing the other night. Fairly...

I did the same thing the other night. Fairly enjoyable outside when it's 9pm or later here right now.
Only drawback is starting the car and pulling back into the garage late at night which my...
Forum: Wheels and Tires Talk Sponsored by The Tire Rack 04-24-2024, 04:52 PM
Replies: 18
Views: 1,361
Posted By Jeff_SS
Toyo R888Rs on my street wheels. Mickey ET...

Toyo R888Rs on my street wheels.
Mickey ET Street R radials on my drag wheels.

The R888Rs hook decent in 2nd if you roll into it. Useless in 1st gear.
The Mickeys hook great at 17psi from a...
Forum: Camaro 1LE Forum 04-06-2024, 05:55 PM
Replies: 266
Views: 283,794
Posted By Jeff_SS
Wish I could still find these. Maybe one day I'll...

Wish I could still find these. Maybe one day I'll get lucky and can get the real ones and not run the reps.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-31-2024, 01:37 AM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Also loving how the red calipers turned out.

Also loving how the red calipers turned out.
Forum: 5th Gen Camaro SS LS LT General Discussions 03-31-2024, 01:32 AM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Well I tried the next step in my journey to solve...

Well I tried the next step in my journey to solve my a/c problem.
Hooked up the autozone vacuum kit to figure it all out.
Pulled 25 and as I let it sit for an hour, it dropped to 15. So clearly I...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-29-2024, 10:50 AM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
I just taped them upright to minimize the...

I just taped them upright to minimize the dripping and then put catch pans underneath to catch what dribbled out.

And my car is Ashen Grey Metallic so I like the red to add a little pop in color. ...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-28-2024, 11:40 PM
Replies: 1,298
Views: 114,007
Posted By Jeff_SS
Finally got around to painting my calipers red....

Finally got around to painting my calipers red. Initially was going to take them off the rotor and paint them in the wheel well without disconnecting the brake line. That was going to be really...
Forum: 5th Gen Camaro SS LS LT General Discussions 03-26-2024, 03:33 PM
Replies: 10
Views: 1,008
Posted By Jeff_SS
I’d love to know the part number on these if you...

I’d love to know the part number on these if you can still get them from GM as OEM parts?
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 11:55 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.