Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


Bigwormgraphix


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.10 seconds. Search: Posts Made By: Ventmaster
Forum: 2016+ Camaro: 6th Gen Camaro general forum 06-10-2024, 09:25 PM
Replies: 14
Views: 747
Posted By Ventmaster
A "hanging fast idle" is nearly always an intake...

A "hanging fast idle" is nearly always an intake side air leak. Besides clamps, etc... be sure to check the torque on your LT2 IM- don't over tighten! Specs should be in inch/pounds. Not very tight...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 06-10-2024, 09:16 PM
Replies: 9
Views: 646
Posted By Ventmaster
very nice indeed! If anyone has been on the fence...

very nice indeed! If anyone has been on the fence about this performance upgrade, this BIG appearance improvement should push you on over. :nod:
Forum: Suspension | Brakes | Chassis 06-07-2024, 06:13 PM
Replies: 6
Views: 408
Posted By Ventmaster
Don't know if Chevy is putting DOT4 in the LT1's,...

Don't know if Chevy is putting DOT4 in the LT1's, but if not, I'd recommend upgrading to Motul 660 or equivalent DOT4 as mentioned in this old how-to post:...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-28-2024, 11:02 AM
Replies: 2
Views: 489
Posted By Ventmaster
Have you checked out Velossa Tech? ...

Have you checked out Velossa Tech?
https://www.velossatechdesign.com/
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-28-2024, 10:59 AM
Replies: 4
Views: 658
Posted By Ventmaster
I have no idea what's involved with that...

I have no idea what's involved with that conversion, but my best first guess would be to disconnect the battery for a bit and try rebooting her. Good luck. :nod:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-24-2024, 09:00 PM
Replies: 28
Views: 2,123
Posted By Ventmaster
I've had excellent luck with both a full-size...

I've had excellent luck with both a full-size extended cab Chevy 4X4 truck and a Nissan Sentra (half 2000 model welded to half a 2001) both with "salvage titles". Both vehicles just wouldn't die-...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-16-2024, 01:40 PM
Replies: 27
Views: 1,491
Posted By Ventmaster
Gotta say I did jump on the MSD/95mm TB talked...

Gotta say I did jump on the MSD/95mm TB talked about in wnta1ss's old thread. Non-ported MSD and unported 95mm. No tune. Car continued to run very strong without adverse effect. My seat of the pants...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-16-2024, 12:59 PM
Replies: 14
Views: 1,538
Posted By Ventmaster
Gotta go with Kamaro6, tire imbalance is the...

Gotta go with Kamaro6, tire imbalance is the first thing to check out IMHO. Remember- KISS! :nod:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-08-2024, 05:14 PM
Replies: 20
Views: 1,574
Posted By Ventmaster
Yes the shifter "self-centers" in neutral- right...

Yes the shifter "self-centers" in neutral- right between 3rd and 4th gear. When I'm shifting from 2nd to 3rd, I let it move over and then push straight ahead with complete confidence it's gonna go...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-07-2024, 10:57 PM
Replies: 20
Views: 1,574
Posted By Ventmaster
:laughabove: Well done sir! We both knew...

:laughabove: Well done sir!
We both knew exactly where that belonged. :happy0180:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-07-2024, 01:33 PM
Replies: 20
Views: 1,574
Posted By Ventmaster
Booher I thought you were fearless! But if you...

Booher I thought you were fearless! But if you don't want to do the work (for once-LOL), I trusted my dealer this one time and have had no regrets. It's solid and I've been enjoying it for quite some...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-07-2024, 01:13 PM
Replies: 20
Views: 1,574
Posted By Ventmaster
I'm pretty sure if your Chevy dealer installs it,...

I'm pretty sure if your Chevy dealer installs it, it can't be used to void a warranty.
And as olrocker pointed out, then you can display one of these which I think I paid $1.98 for on Ebay several...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-06-2024, 09:48 PM
Replies: 20
Views: 1,574
Posted By Ventmaster
Gentlemen- are you aware Chevy offers a "short...

Gentlemen- are you aware Chevy offers a "short throw" shifter (lifted from the 1LE I think), for all their 6speed manual camaros. That means they have a thoroughly written, detailed "how to" on...
Forum: Transmissions 05-06-2024, 11:23 AM
Replies: 5
Views: 739
Posted By Ventmaster
OP we all got to vent from time to time, even me-...

OP we all got to vent from time to time, even me- LOL.
Hopefully you were doing this work to upgrade to a Hurst short throw shifter. If that's the case, in a couple weeks you'll be back in love with...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-03-2024, 08:54 PM
Replies: 27
Views: 1,491
Posted By Ventmaster
The new sensor with constantly monitor what's in...

The new sensor with constantly monitor what's in the tank and deliver adequate fuel/air mixtures that will allow more spark advance because the higher ethanol content is a great octane booster....
Forum: Suspension | Brakes | Chassis 05-03-2024, 05:54 PM
Replies: 2
Views: 419
Posted By Ventmaster
It is amazing how tighter those bolts have to be...

It is amazing how tighter those bolts have to be when you go another 90 degrees past 74lb/ft isn't it. IMHO if the bolt didn't snap at 10-15 degrees more, you will be fine. :nod: I would not...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 05-03-2024, 05:32 PM
Replies: 27
Views: 1,491
Posted By Ventmaster
You know the flex-fuel mod is the easiest, least...

You know the flex-fuel mod is the easiest, least expensive, and by far biggest bang for your buck, right? E-85 will give slightly lower mileage but at a lower price per gallon. The mod and follow-up...
Forum: Suspension | Brakes | Chassis 05-02-2024, 08:19 PM
Replies: 17
Views: 2,146
Posted By Ventmaster
:fighting0056: Get'em Andrew!

:fighting0056: Get'em Andrew!
Forum: Camaro DIY & HOW-TO instructions & discussions 05-02-2024, 08:06 PM
Replies: 11
Views: 815
Posted By Ventmaster
When it comes to ASSuming someone knows better,...

When it comes to ASSuming someone knows better, you can never let your guard down. I didn't trust the local Big Tire specialist's to remove or replace my wheels when I replaced my OE run-flats. I...
Forum: ZL1 Discussions 05-02-2024, 07:15 PM
Replies: 29
Views: 1,137
Posted By Ventmaster
LOL- these cars are the closest you can get to a...

LOL- these cars are the closest you can get to a high-powered bike but on 4 wheels unless you have a great deal more $ to spend. I've been riding over 50 yrs but just sold my FZ09 to the son-in-law...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 05-02-2024, 06:57 PM
Replies: 15
Views: 1,631
Posted By Ventmaster
OP and our LA angel- thank you for following this...

OP and our LA angel- thank you for following this and please do keep us posted. Subscribed. :pop2:
Forum: Suspension | Brakes | Chassis 05-01-2024, 11:46 AM
Replies: 3
Views: 457
Posted By Ventmaster
OP how many miles do you have on your car? (so I...

OP how many miles do you have on your car? (so I can have an idea when to start saving extra $!) :fear:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-21-2024, 11:14 PM
Replies: 3
Views: 708
Posted By Ventmaster
I know my limitations, so I can't help ya. But...

I know my limitations, so I can't help ya. But reposting this in the Brakes/Chasis/Suspension forum or ask any of these guys and I'll bet they can help you...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 04-21-2024, 03:58 PM
Replies: 7
Views: 762
Posted By Ventmaster
OK- since I kind've made light of your situation,...

OK- since I kind've made light of your situation, I decided to go out and check my Mishimoto baffled can as well (I think that's what your pic shows, right). Since I had changed my oil last because...
Forum: V8 LT1 Engine, Exhaust, and Bolt-Ons 04-21-2024, 02:22 PM
Replies: 7
Views: 762
Posted By Ventmaster
OP I sincerely hope this turns out to not be a...

OP I sincerely hope this turns out to not be a serious issue- but am I the only one who thought, "Man, that sounds like a song lyric" when they read your thread title- LOL!
Sorry, I may have wasted...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-21-2024, 02:08 PM
Replies: 5
Views: 672
Posted By Ventmaster
+1, my Cen-Tech has done everything I've needed...

+1, my Cen-Tech has done everything I've needed very reliably. It will not provide all the abilities of the HP tuner equipment but can read and clear codes. Along with providing some other helpful...
Forum: Suspension | Brakes | Chassis 04-20-2024, 02:36 PM
Replies: 28
Views: 2,636
Posted By Ventmaster
Yep, thought maybe a more appropriate screen name...

Yep, thought maybe a more appropriate screen name would be Capt. Obvious!?
Sez so much but reveals nothing we weren't already aware of. :noidea:
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-20-2024, 02:19 PM
Replies: 6
Views: 993
Posted By Ventmaster
Now that's a problem! Check this 1983 movie...

Now that's a problem! Check this 1983 movie trailer it still looks good!
https://www.bing.com/videos/riverview/relatedvideo?q=christine&mid=E733E98719AFA1FE6512E733E98719AFA1FE6512&FORM=VIRE
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-20-2024, 02:10 PM
Replies: 32
Views: 3,431
Posted By Ventmaster
Sorry for the turmoil folks- unintended...

Sorry for the turmoil folks- unintended consequences. I had thought I had accepted the Camaro's fate and hated that "they" had made another version of Mustang that Chevy could have out engineered.
I...
Forum: 2016+ Camaro: 6th Gen Camaro general forum 04-18-2024, 08:16 PM
Replies: 32
Views: 3,431
Posted By Ventmaster
Thought I was over the death of Camaro- again, but..

Then I saw Shelby American's newest version of an upgraded Mustang...
C'mon Chevy, you could've continued to beat these guys! But (grudgingly), nicely done Shelby (it still looks more like a Camaro...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 12:47 AM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.