Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums


BeckyD @ James Martin Chevy


Showing results 1 to 30 of 500
Search took 0.12 seconds.
Search: Posts Made By: camguynj
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-16-2024, 04:45 PM
Replies: 2
Views: 178
Posted By camguynj
Thanks for the reply, make sense. I’m pretty sure...

Thanks for the reply, make sense. I’m pretty sure its the clutch slipping as I noticed recently it didnt take much depression to engage it. It’s in the garage with chocks
as I’m reluctant to drive...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-15-2024, 09:12 PM
Replies: 2
Views: 178
Posted By camguynj
M6 rolling on incline - HELP

My ebrake went limp today and car will inch roll on incline in any gear with clutch released! 53k original owner daily driver miles, no clutch chatter. Help thoughts? Thanks
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-08-2024, 08:31 PM
Replies: 369
Views: 74,661
Posted By camguynj
Yeah I thought of that but the cost of a used one...

Yeah I thought of that but the cost of a used one added to the cost of the new shaft starts to get near not being worth it. I tried finding just the flange coupler but can’t seem to find the eom part...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-08-2024, 04:12 PM
Replies: 369
Views: 74,661
Posted By camguynj
Any ideas on how to get the flange measurements?

Any ideas on how to get the flange measurements?
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-08-2024, 10:18 AM
Replies: 369
Views: 74,661
Posted By camguynj
Found out FastShafts only makes custom DS. They...

Found out FastShafts only makes custom DS. They could make a 3” aluminum with a slip-joint for a little more than half the price of GulfCoast or DSS, but they would need the flange pattern and bolt...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 10-02-2024, 02:53 PM
Replies: 369
Views: 74,661
Posted By camguynj
Anyone know anything about FastShafts? I see...

Anyone know anything about FastShafts? I see they offer a 3” aluminum for late model cars weighting only 7lbs?

https://www.fastshafts.com/products/driveshafts/
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-24-2024, 10:11 PM
Replies: 369
Views: 74,661
Posted By camguynj
I believe GC said some time this year they...

I believe GC said some time this year they started using a new balancer at higher rpm so that should offer some improvement compared to the original shaft balance
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 07-24-2024, 07:15 AM
Replies: 369
Views: 74,661
Posted By camguynj
How does the balance sheet for the new shaft...

How does the balance sheet for the new shaft compare to the sheet from first shaft that was rebalanced?
Forum: Camaro Photos | Spyshots | Video | Media Gallery 07-19-2024, 09:35 PM
Replies: 20
Views: 10,116
Posted By camguynj
How about some pics

How about some pics
Forum: 5th Gen Camaro SS LS LT General Discussions 07-18-2024, 05:41 PM
Replies: 14
Views: 910
Posted By camguynj
Glad to hear it! BTW did you ever put the rear O2...

Glad to hear it! BTW did you ever put the rear O2 extenders on?
Forum: 5th Gen Camaro SS LS LT General Discussions 06-09-2024, 09:23 AM
Replies: 30
Views: 40,160
Posted By camguynj
Good luck! Also check this out … it suggests a...

Good luck! Also check this out … it suggests a weak battery could be the reason readiness monitors won’t ready
...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-08-2024, 02:50 PM
Replies: 30
Views: 40,160
Posted By camguynj
Don’t know why readiness monitors won’t clear if...

Don’t know why readiness monitors won’t clear if you don’t have any cels and completed a drive cycle
:noidea: ask tuner. So not sure if BigDaddies will help. How many miles ago did you last have a...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-08-2024, 10:44 AM
Replies: 30
Views: 40,160
Posted By camguynj
The rear O2s should have been turned off in the...

The rear O2s should have been turned off in the tune. Ask them if they were. Also check these out. Fixed my problem :thumbsup: after I added HF cats prior to getting tuned for my cam
...
Forum: 5th Gen Camaro SS LS LT General Discussions 06-08-2024, 03:22 AM
Replies: 30
Views: 40,160
Posted By camguynj
You need a tune for the new cam, only way!

You need a tune for the new cam, only way!
Forum: General Automotive + Other Cars Discussion 06-06-2024, 04:49 AM
Replies: 13
Views: 3,750
Posted By camguynj
Pretty cool! I’d consider if in the $70k range...

Pretty cool! I’d consider if in the $70k range but $150k to start …and no vinyl roof (I was around when the original first out). I’m out
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 05-29-2024, 06:55 PM
Replies: 8
Views: 684
Posted By camguynj
Thanks! What a difference in sound. Wish I did it...

Thanks! What a difference in sound. Wish I did it sooner.
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 05-29-2024, 06:38 AM
Replies: 8
Views: 684
Posted By camguynj
Amp is in and playing fine … turn signal blinker...

Amp is in and playing fine … turn signal blinker sound is louder too! I did wind up using the lower trunk cowling stud but didn’t screw the cargo net retainer nut back on. Both cowling and net fit...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 05-26-2024, 03:34 PM
Replies: 8
Views: 684
Posted By camguynj
That battery post terminal isn’t really a ground...

That battery post terminal isn’t really a ground as it’s part of the battery and not the chassis. I’m already using the trunk ground stud for two other grounds so I’m reluctant to disturb it to add...
Forum: Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum 05-26-2024, 01:07 PM
Replies: 8
Views: 684
Posted By camguynj
OK to use for Amp Ground?

I want to use one of the studs that holds the trunk cowling as the ground for a replacement amp. I wire brushed the pain off it and got 12+v reading
at the stud base. Is there any danger to screw...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-19-2024, 09:01 AM
Replies: 12
Views: 877
Posted By camguynj
I got nothing else to offer. Maybe EPS unit is...

I got nothing else to offer. Maybe EPS unit is actually bad. Does car go into limp mode ?
Forum: 5th Gen Camaro SS LS LT General Discussions 05-05-2024, 11:49 AM
Replies: 12
Views: 877
Posted By camguynj
You’re welcome. Good Luck! Post back with an...

You’re welcome. Good Luck! Post back with an update.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-04-2024, 08:02 PM
Replies: 12
Views: 877
Posted By camguynj
Being the problem is still happening with the...

Being the problem is still happening with the Dashlogic removed and that you addressed all grounding points maybe it’s the connection harness socket… check for fraying and try applying some carbon...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-04-2024, 08:44 AM
Replies: 12
Views: 877
Posted By camguynj
I had the same problem after having Dashlogic...

I had the same problem after having Dashlogic plugged in for several months. I unplugged it and never had the problem again. My guess is that under circumstances it interferes OBD2 CAN :noidea: Maybe...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-18-2024, 06:10 PM
Replies: 39
Views: 3,268
Posted By camguynj
Damm :eyebulge: What size rear ?

Damm :eyebulge: What size rear ?
Forum: 5th Gen Camaro SS LS LT General Discussions 04-17-2024, 11:52 PM
Replies: 111
Views: 9,455
Posted By camguynj
So what was done to make the a/c cold again ?

So what was done to make the a/c cold again ?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-10-2024, 07:47 AM
Replies: 133
Views: 18,239
Posted By camguynj
Glad to hear! Now go out and :burnrubber: for...

Glad to hear! Now go out and :burnrubber: for lost time
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 04-03-2024, 07:07 PM
Replies: 39
Views: 3,268
Posted By camguynj
Just curious why you selected GC instead of DSS ?

Just curious why you selected GC instead of DSS ?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-02-2024, 06:35 PM
Replies: 133
Views: 18,239
Posted By camguynj
Once again a respectful and comprehensive reply!...

Once again a respectful and comprehensive reply! I can certainly understand not being able cover all tuning changes associated with a cammed car, but I think it would be useful to mention in the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-02-2024, 06:20 PM
Replies: 133
Views: 18,239
Posted By camguynj
You’re didn’t missi anything. It’s just too bad...

You’re didn’t missi anything. It’s just too bad GPI doesn’t mention in the product description that on cammed & tuned cars that if those codes weren’t tuned out that you might experience problems, it...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 04-02-2024, 06:19 AM
Replies: 133
Views: 18,239
Posted By camguynj
I wasn’t questioning your ability, I was just...

I wasn’t questioning your ability, I was just offering things to look at that might be the problem and save you money for paying for a retune. I would have thought GPI would have mentioned the need...
Showing results 1 to 30 of 500

 
Forum Jump

All times are GMT -5. The time now is 06:49 PM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.