Homepage Garage Wiki Register Community Calendar Today's Posts Search
#Camaro6
Go Back   CAMARO6 > Search Forums
Reload this Page Search Results


BeckyD @ James Martin Chevy


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.07 seconds. Search: Posts Made By: CamaroCracka
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons Yesterday, 02:01 PM
Replies: 12
Views: 275
Posted By CamaroCracka
I have the 10295 in both my builds and the vert...

I have the 10295 in both my builds and the vert behaves just as you described. The turbo car gets below 20 psi at idle when it gets really warm, so I started running 40wt oil. I'm pretty sure the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 09-17-2024, 07:28 PM
Replies: 29
Views: 2,689
Posted By CamaroCracka
I run E85 and it can go a few weeks between...

I run E85 and it can go a few weeks between drives. My mud truck runs it too and it goes longer than that between trips.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-17-2024, 06:06 AM
Replies: 130
Views: 61,400
Posted By CamaroCracka
I was told the ZL1 shaft was actually a different...

I was told the ZL1 shaft was actually a different length than the SS.

The only difference in the transmission flange is that the holes are bigger to accommodate the larger bolts on the ZL1....
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-15-2024, 06:09 AM
Replies: 17
Views: 785
Posted By CamaroCracka
Glad you got it worked out.

Glad you got it worked out.
Forum: Autos For Sale / Wanted 09-15-2024, 06:08 AM
Replies: 12
Views: 423
Posted By CamaroCracka
As much as I hate Facebook, it is a better place...

As much as I hate Facebook, it is a better place to list the car, but don't list it in the groups because trollers will only tell you it's worth 15k tops. You can turn off comments to prevent that.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-13-2024, 12:58 PM
Replies: 17
Views: 785
Posted By CamaroCracka
Based on your drawing, you will have .086 before...

Based on your drawing, you will have .086 before the slave is fully compressed. The bearing is supposed to ride on the pressure plate on these and other cars. The CSC just can't be fully compressed...
Forum: Suspension / Brakes / Chassis 09-13-2024, 08:45 AM
Replies: 21
Views: 2,766
Posted By CamaroCracka
Check out the Gen6 ZLE fronts. They are huge. I...

Check out the Gen6 ZLE fronts. They are huge. I can barely fit my 18" drag pack over them. It is a bit more costly to set up.
Forum: Suspension / Brakes / Chassis 09-13-2024, 05:26 AM
Replies: 21
Views: 2,766
Posted By CamaroCracka
My last coach at Sebring was running a Gen4 with...

My last coach at Sebring was running a Gen4 with C5 brakes, so maybe that is ticket for those cars.

I thought the same way when I first wanted to track. Four piston Brembos were the best brakes I...
Forum: Suspension / Brakes / Chassis 09-12-2024, 07:43 PM
Replies: 4
Views: 255
Posted By CamaroCracka
Aligned and all is back to normal. Receipt said...

Aligned and all is back to normal. Receipt said they centered steering the and reset the SAS all for in the price of the alignment.
Forum: Suspension / Brakes / Chassis 09-12-2024, 07:41 PM
Replies: 21
Views: 2,766
Posted By CamaroCracka
My point is the red group are the most...

My point is the red group are the most experienced drivers and I guess I'm just hard on gear.

After I roasted the brakes, I asked a number of guys who track a good bit including the mechanics who...
Forum: Suspension / Brakes / Chassis 09-12-2024, 07:58 AM
Replies: 21
Views: 2,766
Posted By CamaroCracka
Not everyone is driving in the red group. On my...

Not everyone is driving in the red group. On my first outing at Sebring I burned up a fresh track set up from EBC in one session. Obviously, I could do better with my braking or I could put on a ZL1...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-12-2024, 07:49 AM
Replies: 17
Views: 785
Posted By CamaroCracka
According to your numbers there is too little...

According to your numbers there is too little room between the CSC and pressure plate. You don't need any shims. In other words, a shim would be making your 3.255 bigger and your .086 number smaller....
Forum: 5th Gen Camaro SS LS LT General Discussions 09-12-2024, 07:42 AM
Replies: 7
Views: 388
Posted By CamaroCracka
I hear ya! Working from home I don't get to drive...

I hear ya! Working from home I don't get to drive much, but they bring a smile to my face every time I go in the garage. The turbo car got a bunch of rock chips from daily driving when I was still...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-11-2024, 10:34 AM
Replies: 18
Views: 705
Posted By CamaroCracka
I bought a gallon of tire shine years ago and am...

I bought a gallon of tire shine years ago and am still using it inside and out, but I did put in the leather overlays from RedLine just because I prefer the leather to plastic. The downside to the...
Forum: Suspension / Brakes / Chassis 09-08-2024, 01:04 PM
Replies: 4
Views: 255
Posted By CamaroCracka
Turned out to be the rack. The real...

Turned out to be the rack. The real disappointment was the brand new OEM pump I put on failed on the test drive. Old pump is back in, albeit a little melted. It is also throwing a C0710-5A Steering...
Forum: 5th Gen Camaro SS LS LT General Discussions 09-08-2024, 06:27 AM
Replies: 5
Views: 277
Posted By CamaroCracka
From the pic it looks like the plastic bushing...

From the pic it looks like the plastic bushing with green paint on it is out of the hole. Perhaps that bushing is worn out.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 09-01-2024, 01:40 PM
Replies: 17
Views: 785
Posted By CamaroCracka
IIRC, only replacement aftermarket clutch I...

IIRC, only replacement aftermarket clutch I thought would do well was from Spec, but I went with the Mantic anyway. You're at the limits of single disc from any mfg, so I would think hard about just...
Forum: Suspension / Brakes / Chassis 09-01-2024, 10:53 AM
Replies: 4
Views: 255
Posted By CamaroCracka
One other thing. Can you take the rack out...

One other thing. Can you take the rack out completely from the bottom of the car or will I have to remove the down pipe or anything else to get it out.

I disconnected toe links and it seems to...
Forum: Suspension / Brakes / Chassis 09-01-2024, 10:39 AM
Replies: 4
Views: 255
Posted By CamaroCracka
Steering Vibration

I took my car to Sebring a few months back and on the first few laps the cutout pipe wore through the power steering return line. I had to drive it a few miles with no power steering fluid to get it...
Forum: V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment 08-19-2024, 07:19 AM
Replies: 56
Views: 14,697
Posted By CamaroCracka
Found the same thing on mine a couple years back...

Found the same thing on mine a couple years back and replaced them with Weatherpack since I could not find that connector. 12ga Weatherpack connector has not melted, but one of the little plastic...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 08-17-2024, 06:00 AM
Replies: 1
Views: 299
Posted By CamaroCracka
Innovators West sells 8 rib balancers in stock...

Innovators West sells 8 rib balancers in stock and overdrive configurations. They also sell a pinning kit that uses a keyway and bolts that thread into the end of the crank. When a lot of people pin...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-13-2024, 07:05 PM
Replies: 42
Views: 1,292
Posted By CamaroCracka
GoPro is a good idea. Something is up with the...

GoPro is a good idea. Something is up with the inner, but odd that the other inner is unaffected.
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 08-13-2024, 10:09 AM
Replies: 4
Views: 363
Posted By CamaroCracka
At 700whp and 10" slicks, I've broken a ZL1 axle...

At 700whp and 10" slicks, I've broken a ZL1 axle and a one-piece driveshaft on the two-step at 14 degrees of retard. I upgraded the axles to Gforce Outlaws before the one-piece drive shaft broke and...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-13-2024, 09:11 AM
Replies: 42
Views: 1,292
Posted By CamaroCracka
Are all the axles breaking in the same place,...

Are all the axles breaking in the same place, e.g. inner joint, outer joint, axle? If it's always the same part, that could help you find the problem.

Under simple stuff first, you are tightening...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-10-2024, 05:38 AM
Replies: 82
Views: 39,828
Posted By CamaroCracka
He did it on a Camaro, but I'm sure lots of cars...

He did it on a Camaro, but I'm sure lots of cars use the same sensors. They have the motion sensor so they turn off when they are not rolling and save battery life.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-09-2024, 05:42 AM
Replies: 82
Views: 39,828
Posted By CamaroCracka
There was a guy on here who built that set up,...

There was a guy on here who built that set up, and did a write up, but the sensors have a motion sensitive sleep mode and activate when the tires start moving, so it did not work for him.
Forum: Camaro V6 LLT Engine, Exhaust, and Bolt-Ons 08-08-2024, 08:48 AM
Replies: 4
Views: 1,959
Posted By CamaroCracka
Pretty sure the ball valve versions leak. You can...

Pretty sure the ball valve versions leak. You can replace them with a Schraeder valve version.
Forum: 5th Gen Camaro SS LS LT General Discussions 08-08-2024, 08:43 AM
Replies: 5
Views: 438
Posted By CamaroCracka
If you don't want it, post it on Facebook as a...

If you don't want it, post it on Facebook as a curb alert and someone will come get it. I have one minus the mufflers tucked away because exhaust does not last forever and that is how long I intend...
Forum: Camaro Z/28 Forum - Z/28 Specific Topics 08-06-2024, 04:16 PM
Replies: 5
Views: 506
Posted By CamaroCracka
I put a set of ZR1 hats on Gen6 ZL1 rings, so...

I put a set of ZR1 hats on Gen6 ZL1 rings, so they might be an option as well. Based on what I saw, I agree that Z28 hats should fit ZR1 rings. This would only be for the fronts as the rear Gen6...
Forum: 5th Gen Camaro SS LS LT General Discussions 08-06-2024, 04:01 PM
Replies: 5
Views: 306
Posted By CamaroCracka
Me either. Three bolts hold it in. Worst case...

Me either. Three bolts hold it in. Worst case whack it, assuming you have removed the axle shaft.
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 07:22 PM.

Contact Us - CAMARO6 - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.