| The Baron |
03-24-2014 11:52 PM |
LSA SUPERCHARGER. ported with 2.38 pulley.
I have a complete lsa 1.9 factory blower. Its been ported and has 2.38 pulley on it. I have a factory balancer and the blower belt acc needed. It also comes with fuel rail and a set of STOCK LSA INJECTORS. . These may or may not be enough for your car. This DOES NOT INCLUDE THE HEAT EXCHANGER or any coolant acc. This blower has 10,000 miles on it and has been serviced with a new snout bearing. It is ready to go.
Before you ask, no, I dont know what you will need FOR SURE to put this on your ls3, but you should only need to extend a few of your plugs ( tb, map, tps) but I HAVE NOT done it myself.
This blower will support 700wheel through a auto..
It will come with lid, coolant brick, portet snout and blower and front eng acc drive and a stock lsa balancer. With this setup it will produce 15#s of boost on a stock motor..
I put this blower on my car to move it around and to make sure the replaced bearing was functional. It can be heard or I can take a vid if desired.
3500$ or best offer.
|
