Speaker tap 2023 1SS vert.
Hi!
I have a Kicker HS8 powered sub i ran in another car that was totally satisfactory for my needs. I need to tap into the rear speakers on my 1SS convertible. I know that i can pull the sail panels in the rear for speaker access but need to tap there and run to the trunk for the amp. The amp needs speaker input from both sides, a hot, and ground. Obviously hot and ground are in the trunk. I was looking but of course the top doesnt want to stay in the half open position. Anyone have any insight as to where to tap in or where the best place to run wires is? Or , can i disconnect the battery while the top is half open so it stays there? thanks! |
This MIGHT help with your question about keeping the top open:
https://www.camaro6.com/forums/showthread.php?t=480519 |
You don't want to tap into the rear speaker signals for your sub: they aren't full frequency range. You want to tap into the front speaker signal.
|
|
2 Attachment(s)
Quote:
If it's non-Bose, you can access the speaker wires at the passenger side dash or at the dash speaker location. If it's Bose (meaning you have the technology package), then you'll want to intercept at the factory sub output. Assuming it's non-Bose, I have all of the 1SS audio schematics. Attached are with and without active noise cancelling, non-Bose. |
Dean and Fernando at Five Star Car Audio agree with Msquared and Keep_hope_alive.
https://youtu.be/xqsvpggwfyE?si=LJ84yocRNzKxctpr |
Don't forget to cut your active noise canceling wire!
|
1 Attachment(s)
Quote:
Disconnecting the microphones is the easiest solution that doesn't require cutting wiring, and there are two mics. How the system integrates depends on the trim level/audio system you have. |
Quote:
|
I also intercepted my wiring with a breakout harness:
https://hosting.photobucket.com/imag...910_230226.jpg https://hosting.photobucket.com/imag...910_230801.jpg |
Thanks all! I am digging back into the project.
|
does anyone have any insight about how to get into the trunk though....the convertible top in the way is still a thing.
|
All times are GMT -5. The time now is 11:44 PM. |
Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.